Electronics Forum | Thu Oct 03 10:21:30 EDT 2019 | cbart
Hello all!! we are having a heck of a time getting a TE Connector to solder TE P/N 2305018-2. the part design is terrible!! the parts tips forward and rocks side to side when mounted. we are getting many un-soldered leads. and the design does not len
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Mon Oct 07 17:03:20 EDT 2019 | dwl
Personally I hold the opposite opinion on the Juki post. To me it felt like a blatant marketing attempt. A better way would have been for Juki to publish a white paper or pay for advertising. Its one thing for a company to respond to someone else's q
Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
Electronics Forum | Wed Oct 09 13:18:46 EDT 2019 | dwl
What is the advantage of dispensing dots over dispensing a line? I don't see any reason why dots wouldn't work. You might have to experiment a bit to dial in the right volume and spacing to get the desired end result, but it shouldn't be hard. Fisna
Electronics Forum | Wed Oct 16 10:51:35 EDT 2019 | radialvalve
Hi Joe, sorry for the delay in responding to your request, hope it's not too late. There are several questions to be answered before we can guide you to the best solution to meet your Thermal Gel Dispensing Needs. I would like the opportunity to disc
Electronics Forum | Wed Oct 09 17:05:36 EDT 2019 | slthomas
I think you answered your own question by providing new information. If your AOI isn't capable of catching the vast majority of SMT soldering issues and you're SMT process isn't functioning at a very high level, you probably should count on inspect
Electronics Forum | Mon Oct 14 07:44:59 EDT 2019 | spoiltforchoice
It does seem to be very much hardcoded proprietary algorithms with all the parameters and maths done on the local machine. No knowledge sharing between machines or back to the vendor ("crowd sourcing" as it were) no cloud magic etc. VI appears to be
Electronics Forum | Thu Oct 10 03:18:28 EDT 2019 | bukas
Hey guys, my DEK265 GSX is acting funny. It misprints half of the boards. The one half when squeegees move away from operator to be precise. When squeegees are moving towards operator print is perfect. In both cases actuators are moving prior to prin
Electronics Forum | Fri Oct 11 03:06:00 EDT 2019 | bukas
Hello Dekhead, it is a constant offset, like 0.5 mm to right when machine prints away from operator. When print goes towards the operator there is no offset. I swapped X5 and X6 cards with spares I got but still same result . I set the program to hav
