Electronics Forum | Wed Aug 25 00:10:13 EDT 2021 | sarason
The company that does this is McDermid. There are multiple different ways of doing it. Screen print silver paste onto the mylar, "activate" the film to be conductive, then plate in copper. These processes are found in the patent literature which is e
Electronics Forum | Thu Aug 19 20:28:27 EDT 2021 | stephendo
We have it set up in our ERP system. When it produces the Work Order it adds whatever extra parts we say. And we have a relatively inexpensive system I would think most systems for electronic manufacturing would have that ability. A few lifetimes
Electronics Forum | Tue Aug 24 20:06:24 EDT 2021 | demradarmfg
I have mentioned this over 6 different support tickets (3 of which had no reply and were dedicated to this inquiry.) I have also called twice with no answer and no call back. I can try again but am definitely not impressed with them. The only respon
Electronics Forum | Thu Aug 26 20:35:33 EDT 2021 | kumarb
Hi. Have the Emerald-X (Yamaha YV88X) unit. Works fine. Using F9 (Teach & Trace), we can position to most locations on the front feeders (not to the extreme left or extreme right due to the head design). Should the unit be able to do the same for t
Electronics Forum | Sun Aug 29 12:29:37 EDT 2021 | jojoled
Hi, can anybody provide a Installation software for JUKI KE/FM760L,named as "Juki Flexible mounter 1.35 " or similar version? I need to change the PCB max.width limit from 410mm to 560mm(heads can travel that far, no problem) and on disk the MSDOS so
Electronics Forum | Tue Aug 31 21:10:51 EDT 2021 | wolverine_nz
Thanks for the heads-up for this company. Would rather pay extra to gain confidence to the equipment you're buying especially if used. 1) Buy from a reputable and trusted company. 2) Source out for a technical support company available in your regio
Electronics Forum | Fri Sep 03 16:43:13 EDT 2021 | djenkins62
Hello Everyone, We are building devices to remove moisture from boards prior to rework where it does not require the use of ovens as stated in IPC-TM-650, Method 2.6.28. Instead of evaporation, we use moisture magnets to pull out the part......even
Electronics Forum | Thu Sep 09 18:58:11 EDT 2021 | cyber_wolf
I have never witnessed a "worn out" stencil in my 30+ years. Take that with a grain of salt..My environment is CM so stencil usage is somewhat limited. I have seen "coined" stencils. They look funky but some schools of thought say they work better
Electronics Forum | Fri Sep 10 14:21:39 EDT 2021 | majdi4
Evtimov , i agree with Thomas.. you don't have to take your mesure in the middle of the stencil since the sheet of the stencil has the same thickness everywhere either in the corners or in the middle.. So you can ask from your stencil supplier to mak
Electronics Forum | Mon Sep 27 10:53:24 EDT 2021 | majdi4
Thank you all for your quick reply ! the problem is solved without making any intervention on line .. 0% defect rate for the moment .. for all of you who said "try rotating the board 180 °", we can't do that because the panel contains 2 boards head t
