Electronics Forum | Thu Apr 14 17:24:06 EDT 2022 | cbart
depends on board finish and PCB substrate materials. If you were using OSP or silver finished bare boards the time to process is less than an ENIG or HASL finished. certain substrate material absorb more moisture than others or at a quicker rate. so
Electronics Forum | Fri Apr 15 09:56:17 EDT 2022 | winston_one
Thank's Dennis. I'm also now think in this direction. Process was adjusted and soldering are good. But one from five boards can have this effect with bubbles and strange uneven distribution of solder inside the barrel. Probably copper is too thin and
Electronics Forum | Sun Apr 17 00:04:03 EDT 2022 | klauss
I am mounting 3535 Cree High-power leds with p&p machine. First nozzle picks up the led normally and then it's placed good but after 4-5 times nozzle picks up the led like at an angle. looks like it holds the led from the side edge of the dome.
Electronics Forum | Mon Apr 18 12:14:39 EDT 2022 | proceng1
As far as hole fill, as was stated above, class 2 only requires 50% up-fill. In order to get better up-fill on the initial pass, you may need to consider more pre-heat. Also, better application of flux. Are you using a drop jet, or a spray? You
Electronics Forum | Tue Apr 19 21:23:37 EDT 2022 | kumarb
Hi. On our YV88X (Emerald-X), we use the edge clamp + Push-IN clamp to secure the PCB. The push-in metal part pops up fine but unable to move this piece to the LEFT or RIGHT using the dial inside the machine. The latch inside the machine is rotated '
Electronics Forum | Wed Apr 20 18:06:37 EDT 2022 | kumarb
For future readers - just needed a little bit of lube. Many thanks to Michal & the staff @ Trans-Tec (USA) for their excellent support, as always. Please see attached. For our (dated) machine, the black dial would turn only after hitting the gym
Electronics Forum | Thu Apr 21 06:05:48 EDT 2022 | sophyluo1985
Hi,Dear All,Recently we have many customers asking us, FUJI NXTIII pick and place machine can use W08c feeder or W08f feeder, which one is better? We know the W08c will cost less than the W08f feeder. But there will still be some people who will be c
Electronics Forum | Thu Apr 21 20:45:09 EDT 2022 | SMTA-68235204
Hello: I am wondering what you all do with your flux stone at the end of the day? Do you remove the unit and store it in DI water or your thinner for the flux? Do you leave the stone in and just add your thinner to get to the correct specific gravity
Electronics Forum | Fri Apr 22 15:02:39 EDT 2022 | proceng1
We used to empty the tank on Friday and let the stone basically dry out over the weekend. That was before I got involved with it. We were constantly replacing stones. Now, we empty the flux Monday morning and replenish with new. That way the stone
Electronics Forum | Fri Apr 22 18:17:14 EDT 2022 | swilson
Hello I experiencing major misalignments. I am using a Nichia LED package size@ y=.086,x=0.33mm, with recommended solder pad pattern x.086mm, y=.033. Note here is the kicker the PCB pattern does not meet this requirement. The PCB pad landing is based