Electronics Forum | Tue Aug 19 13:35:51 EDT 2008 | stefi
Hello, I need an advice regarding the next issue: in the case of Assembleon Topaz or Emerald SMT machines, is there necessary to teach first the block repeat coordinates and after that the PCB fiducial coordinates when you do not have these coordina
Electronics Forum | Fri Aug 22 15:27:13 EDT 2008 | wayne123
this is the order that I use. 1. Teach pcb origin 2. Teach fiducial location 3. dial in vision on fid in mark info. 4. go into mount and verify that the primary image is on in x/y (after perfoming a teach trace condition) and then do any offsetts if
Electronics Forum | Wed Aug 20 20:10:30 EDT 2008 | davef
Naw, accounting is boring. Standoff could be an issue. Coupla things: * Above 30 thou, just about any cleaning process, more sophisticated than a garden hose, will produce acceptable results * Below 10 thou, can be cleaned with best efforts, but not
Electronics Forum | Sat Aug 23 08:43:32 EDT 2008 | davef
Ugh, there are more reasons that immersion silver [IAg] to go yellowish than pigs at the county fair. That aside, sulphur is one of the reasons, as you say. The sulphur can be from a variety of sources, such as: * Pollution in the air * Ill advised p
Electronics Forum | Mon Aug 25 01:19:51 EDT 2008 | chrispy1963
We've got an older Conceptronics HVA102, 7 Zone, relow oven running software with the following info: (1) Machine Software Ver. Date: 9-1-94-Windows Rev 2.50c. (2) EPROM rev for the machine is: 386 AT WINDOWS (3) 486DX2 PC running Windows 3.1 as
Electronics Forum | Mon Aug 25 19:27:11 EDT 2008 | Mike Konrad
There are a number of �low cost� stencil cleaners available. I am a manufacturer of one but I'll list a variety and let the others provide editorial on which is best. Basically, there are three technologies, manual cleaning (solvents and wipes), ul
Electronics Forum | Mon Aug 25 14:55:51 EDT 2008 | grics
I have a question for the manufacturing masters... We are going to start running test trials/DOE of a Urethane Coating (Humiseal 1A33) and I am not sure what to expect. From what I understand, urethane coating is pretty difficult to work. It is supp
Electronics Forum | Wed Aug 27 14:19:40 EDT 2008 | grics
Have you given this information to your paste manufacturer???(Profile, Pics of defects?) The profile seems to look ok(without knowing paste info...) I think the ramprate looks a little aggressive but it could be the scaling of the profile and the i
Electronics Forum | Wed Aug 27 14:38:20 EDT 2008 | rgduval
Does your paste provider recommend a TAL? For the leaded and lead-free pastes that we use, the manufacturer recommends 60 seconds above liquidous. I note that your profile shows the TAL as 30 seconds, which may not be sufficient. That said, tho
Electronics Forum | Thu Aug 28 08:43:56 EDT 2008 | rgduval
You wouldn't think that placement would affect dewetting or solderability....I wouldn't have either, until it was the only thing left in our process, and when we changed it, things got better. I couldn't begin to explain why, either. The only concl