Electronics Forum | Fri Jul 15 13:28:55 EDT 2005 | Brian
A process consists of much more than just thee machine. When developing a cause and effect diagram ffor the process, there are many parameters that fall outside the machine itself. There are Man, Machine, Methods, and Materials. Just monitoring th
Electronics Forum | Mon Mar 03 13:18:02 EST 2003 | msivigny
Hello phil, The use of AOI systems give us the opportunity to auto-collect defect information much the way you're using them now. AOI systems become extremely effective when the collected data is used to perform some positive change into the process.
Electronics Forum | Wed Mar 19 18:40:03 EDT 2014 | guts1872
We use IQ feeders from PPM and cant find any reference material on maintenance and calibration of these feeders. Does anyone here know where I can get repair manuals, diagrams, or any info on these feeders at all?
Electronics Forum | Thu Sep 08 03:18:10 EDT 2005 | dougs
Don't know if you'd be able to register as i'm not sure if you need to have a service contract or not but if you can go to the UIC website and register for the knowledgebase, this service has detailed advice on fault finding on universal machines, i'
Electronics Forum | Tue Jan 07 02:04:45 EST 2020 | robl
Hi Mikey, Your signal pins (2 & 3) for USB1, 2, & 3 are all connected together so there is no way of splitting the incoming signals from the 3 ports. Normally there would be an IC (a USB hub controller) switching between the signals so that the PC
Electronics Forum | Sat Jul 19 12:22:55 EDT 2008 | operator
Are there any softwares OR functions inside of the softwares that allow a designer that is creating a very large complicated wiring diagram with say....many terminal blocks and connectors etc... to run a point to point check on his drawing? Bascially
Electronics Forum | Thu Mar 20 14:58:04 EDT 2014 | aybars
We use IQ feeders from PPM and cant find any > reference material on maintenance and calibration > of these feeders. Does anyone here know where I > can get repair manuals, diagrams, or any info on > these feeders at all? Hi guts1782, IQ feed
Electronics Forum | Fri Jul 21 09:23:05 EDT 2017 | sumote
I am not going to give you any names of equipment manufacturers as I believe most people tend to recommend only what they are familiar with. I have my favorites as, likely, most everyone else does as well. What I will tell you is equally important.
Electronics Forum | Tue Apr 09 21:40:26 EDT 2002 | ianchan
We are a local enterprise with limited resources, just like you described, so hope this experience sharing helps : we place a production Visual Mechanical Inspection (VMI) inspector at the end of each Reflow Oven area, complete with magnify scope 30
Electronics Forum | Tue Nov 08 05:00:23 EST 2005 | rlackey
Hi CW, Regarding orientation, yes, your diagram is right - see the following link for confirmation. http://search.murata.co.jp/Ceramy/image/img/A18X/C2EB3C.PDF Regarding information on bending strength you want to talk to your local Murata office