Electronics Forum | Tue Jul 20 06:25:54 EDT 2004 | resslerr
In addition you may want to research a product offered by Sony...www.timmsweb.com This product has recently exploded onto the market and it has enabled Sony to enjoy a competitive advantage in manufacturing over the last decade. This system has all
Electronics Forum | Sat Jul 24 04:02:18 EDT 2004 | kent_peterson
Two ways at it.You could just put the same nozzle for both the min and max.Or you could move the feeder into a location that has similar parts using the nozzle you want. With the feeder setup it should be optimized for the least amount of nozzle ch
Electronics Forum | Sat Jul 24 04:02:21 EDT 2004 | kent_peterson
Two ways at it.You could just put the same nozzle for both the min and max.Or you could move the feeder into a location that has similar parts using the nozzle you want. With the feeder setup it should be optimized for the least amount of nozzle ch
Electronics Forum | Wed Aug 04 23:12:37 EDT 2004 | dougt
To get you started: You would begin with a comparitor, one input would be referenced to a voltage that you want the output to "trip" at. The second input would be where you apply your "voltage" that you are using to start the motor. The output of
Electronics Forum | Thu Aug 05 13:46:56 EDT 2004 | mdm4ua
I don't know what the availability is in your area but You might want to look into Mydata. The machines are not as fast as some but very versatile and have faster changover than any of the machines that I have seen. PS. I work for a contract manuf
Electronics Forum | Tue Aug 10 07:10:11 EDT 2004 | abraham
Praveen, White powder residue can be produced if you clean the No clean flux residue with isopropyl alcohol. Check whether you are using any IP for local cleaning. In case you want to clean the noclean flux residue ( as per the requirements of conta
Electronics Forum | Sat Aug 14 20:40:20 EDT 2004 | Grant
Hi, We are currently using the profiler built into our Soltec oven, but are looking for something better and does anyone have any ideas. We want to be able to quickly analyze the profile against solder paste and component profiles so we can quickly
Electronics Forum | Wed Aug 18 14:08:12 EDT 2004 | Claude_Couture
I guess you want to try a permanent feeder setup. This is possible if the total number of feeders needed to cover all of the different products can be installed on your machines. Then just use the same setup data for all your product. Each program wi
Electronics Forum | Tue Aug 24 00:37:49 EDT 2004 | Justanobody
Look into the Multi-Job Line Balancer. You select a group of products that you want to run and WHAM-Oh! A setup sheet is created that tells you what you need to move once you run out of room or a part number is no longer needed. Contact Fuji America
Electronics Forum | Mon Aug 23 21:08:48 EDT 2004 | cyber_wolf
One thing to try : Pull the Cognex card out and physically re-seat the memory sticks. Then take a kimwipe or something comprable and wipe the card fingers off with alcohol. We have seen this before. You don't even want to know what MPM will charge
