Electronics Forum | Wed Nov 29 22:16:54 EST 2006 | fishingfool
Have something that should be standard but never is. Cycle time. Long story short. Customer buys system. 8 months later customer says system isn't working as should. Go onsite and find customers application is causing huge maintenance problems. Sol
Electronics Forum | Wed Dec 06 11:16:06 EST 2006 | Todd
Ok, an update... I finally found my 24Vdc. I was trying to use a screw and/or outside of the connector for ground. It was necessary to use the ground IN the connector pins. I believe it was the top/right and 3 o'clock pins that toggled with the 24Vdc
Electronics Forum | Fri Dec 08 02:40:45 EST 2006 | Mike Konrad
Hi 'K', We manufacture both batch and inline defluxing equipment so we have no axe to grind with either technology. There are pros and cons associated with both technologies under specific conditions. Batch machines are typically good cleaners but
Electronics Forum | Tue Jan 09 13:54:10 EST 2007 | jdengler
Hi All, I'm having a problem with a Fuji GP-341. It has squeegee pressure control using a TEAC TD-320A comparator. I cannot get it to measure printing pressure. On the TD-320A it normally reads "2512" then flips to "oFl4" then back to "2512". If
Electronics Forum | Mon Jan 29 10:50:35 EST 2007 | mika
What about the component placement with Head #2? Head # 1 is ok? Is it only the pickup that is the problem and if so, from all feeder banks (front & Rear)? Concider Z-axis height adjustment, procedure is in the manual. You normally don't need to re-
Electronics Forum | Thu Feb 08 13:22:36 EST 2007 | smtstaff
SMTnet is looking for your input on a problem that has started to become serious... You may have noticed that the forum has had some spam posted... in the past serveral weeks in fact several hundred have been posted. We are soliciting your views a
Electronics Forum | Thu Feb 08 13:23:32 EST 2007 | smtstaff
SMTnet is looking for your input on a problem that has started to become serious... You may have noticed that the forum has had some spam posted... in the past serveral weeks in fact several hundred have been posted. We are soliciting your views a
Electronics Forum | Sun Mar 18 23:01:11 EDT 2007 | diesel_1t
Hi there, I want help on the following issue. Where I work, we place a component QFP 256 terminals (20 mil pitch)from hitachi (renesas), we use a MPM UP-3000 screen printer, IP-III placement machine and Vitronics 8 zones reflow Oven. lead plating
Electronics Forum | Sat Mar 24 07:07:52 EDT 2007 | stefi
Hi, Thanks for the reply, The fiducial which posed problems is a 1 mm diameter gold plated circle fiducial. The problem with this is that the vision system sees it darker than the surrounding area. The surrounding area is all copper covered with th
Electronics Forum | Sat Mar 24 12:31:31 EDT 2007 | diesel_1t
Hi there. Ok, i have a little big question for fuji Erudites: when machine run out of parts on any device it tells to machine "parts out (and part number)" So, a signal from anywhere (maybe a PLC output) will tell to the machine "hey i'm out of parts
.gif)
