Electronics Forum: washing and pcb (Page 1 of 92)

PCB washing

Electronics Forum | Wed May 30 18:38:15 EDT 2007 | colormaker


PCB washing

Electronics Forum | Wed May 30 18:28:13 EDT 2007 | russ

you are sure that noone has brought in any alcohol based no clean flux? R

PCB washing

Electronics Forum | Tue Feb 01 03:28:49 EST 2000 | Guo Yingchun

Hi, I want to use ultrasonic machine to remove solder paste from PCB. Can I use water as the solvent? Will it do harm to the PCB? Thanks in advance.

PCB washing

Electronics Forum | Thu May 24 16:59:49 EDT 2007 | pjc

Is wash temp the same in the new washer? I'm thinking that may be a clue. Are you sure nothing else changed, like water supply at all- conditioner? Do you have a supply of DI water?

PCB washing

Electronics Forum | Thu May 24 17:11:22 EDT 2007 | colormaker

Everthing is the same. I did not check water temp or wash cycle time. No DI just straight from water supply. How do I do the DI ? Jerry

PCB washing

Electronics Forum | Thu May 24 23:07:55 EDT 2007 | colormaker

Our filter removes all contaminates authou it takes forever to evaporate 20 gallons it work quite well. I will check with local water supply for mineral analysis. Will a water softener remove the minerals that may be causing the problem ?

PCB washing

Electronics Forum | Fri May 25 13:32:26 EDT 2007 | colormaker

We have 4 diffrent boards that have the problem. The boards have two diffrent suppliers. I dont think this is the case. I more leaning toward not enough rinse cycles in the washer. Jerry

PCB washing

Electronics Forum | Thu May 24 14:44:42 EDT 2007 | colormaker

We use a washer soluable solder flux for our solder wave. We then wash the boards in a dishwasher. We have done it this way for years without problems. We just got a new dishwasher and now we get residue on the solder (white marks) Anyone know of wh

PCB washing

Electronics Forum | Fri May 25 12:27:32 EDT 2007 | bschreiber

You should also check the quality of your compressed air. If the proper filters and desiccants are not in place, you could be recontaminating your washed boards with condensed water and oil residues from the compressed air used for drying. Bill Sch

PCB washing

Electronics Forum | Thu May 24 22:33:07 EDT 2007 | slthomas

By purchasing or leasing a DI system and supplying it for your final rinse, at least. You'll avoid some troublesome ionics on your boards that way. Kind of off topic, but are you filtering or boiling off your washer's waste water or are you sending

  1 2 3 4 5 6 7 8 9 10 Next

washing and pcb searches for Companies, Equipment, Machines, Suppliers & Information

Precision PCB Services, Inc
Precision PCB Services, Inc

Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.

Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider

1750 Mitchell Ave.
Oroville, CA USA

Phone: (888) 406-2830

Sell Used SMT & Test Equipment

High Precision Fluid Dispensers
Selective soldering solutions with Jade soldering machine

High Throughput Reflow Oven
Software for SMT

World's Best Reflow Oven Customizable for Unique Applications