Electronics Forum | Tue Jun 08 13:06:53 EDT 1999 | Kevin Hussey
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Thu May 24 16:45:57 EDT 2001 | kmorris
Hi All: We�ve got a problem here with opens on bottom side wave soldered SOT23s. Based on past experience and review of the SMTnet archives, I feel that our main problem is pad size. We have the same size pads for bottom side SOT23s as we have for
Electronics Forum | Mon Jan 04 11:03:14 EST 1999 | Chrys
| | | We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I rea
Electronics Forum | Wed Jul 02 09:22:20 EDT 2008 | dmunson
Thanks Real Chunks. We currently have an RPS opus selective solder machine that we plan on keeping. It is configured as a 3-nozzle (!) one-pump (!!) point selective solder machine w/ nitrogen preheat. Custom wet nozzles. We use lead free SN100C sold
Electronics Forum | Tue Sep 20 11:59:06 EDT 2011 | SheanDalton
Check specific gravity: According to a quick web search, the specific gravity should be 0.813 ± 0.003. If you have records of the specific gravity, compare current reading to past readings. Check pressure near stone: if you have records, compare
Electronics Forum | Mon Jan 04 22:59:23 EST 1999 | Kris Ewen
I'd like to add something about the ECD product. During a past work term (I'm a a co-op student) in an SMA plant, I worked extensively with the Super MOLE Gold in developing the reflow profiles for high-mix, low-volume production. I was 'married' t
Electronics Forum | Sun Mar 07 09:24:55 EST 1999 | Scott Cook
| Hi Ya'll... | it's a Soltec Prisma and the conveyer keeps jamming. What it's doing is up at the exit end where the drive motor is, the chain keeps wrapping itself around the drive sprocket and jamming...this is on the backside rail, the frontside
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Mon Jan 28 08:07:44 EST 2002 | JohnW
Sorry I keep forgetting you lot are backwards in the old metric system :0) anyhoo, yes IPC, the bastions of right well as long as your board is only 1.6mm thick (sorry 62mils)say that you need 75% min general and 50% on ground planes. I'd like to se
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all