Electronics Forum | Thu Sep 14 14:08:41 EDT 2000 | Bob P
We are currently looking for a new vendor who specializes in selective wave solder fixtures within Southern New Hampshire or Mass. Can anyone recommend a good supplier(s)?
Electronics Forum | Fri Sep 15 09:13:18 EDT 2000 | bobbemc
Bob, We are a manufacture of selective wave solder fixtures. I would like an oppurtunity to offer you assitance. Please contact me at 215-340-0650 x234. Look forward to hearing from you. Bob Baginski EMC Global Technologies bobb@emcgti.com
Electronics Forum | Fri Sep 15 16:41:43 EDT 2000 | Dave F
Consider searching the SMTnet archives for the source you seek. Several wave soldering fixture suppliers are listed there.
Electronics Forum | Thu Jun 15 16:19:08 EDT 2000 | LeeAnne Wambolt
Raeto, IPC-SM-782 will give land sizes for both reflow and wave soldering. LW
Electronics Forum | Wed Mar 08 21:16:38 EST 2000 | Dave F
Wolfgang: I agree that the IPC pads are reflow / top side wave solder. We run bottom-side PCLL at 45� to the wave with fairly involved solder thieves. Ta. Dave F
Electronics Forum | Fri Mar 02 16:47:39 EST 2001 | traviss
If the thinner you are using is 4662 and the correct amounts that should not be the problem. Is this the first solder operation? I would start by looking for rosen or no clean flux getting on the boards at some point before wave soldering and not bei
Electronics Forum | Wed May 05 12:03:11 EDT 1999 | Edmund Loh
Can anyone pls email me a typical temperature profile for wave soldering process. Thank you vey much. rdgs...
Electronics Forum | Fri Apr 23 12:59:18 EDT 1999 | Upinder Singh
Hi everybody, I would like to bench mark the quality out of our wave soldering m/c as far as DPPM levels are concerned. Can somebody provide me with some figures at their site or anywhere else for the same. Thanks Upinder ======
Electronics Forum | Fri Jun 19 01:27:31 EDT 1998 | Mark Chua
Speaker made of ABS material could not withstand temperature of 250 C after wave soldering, please advise what is the guidelines for such material to pass thru wave soldering process, is there any guide books for my reference.
Electronics Forum | Mon Jun 15 14:00:32 EDT 1998 | Pete
Yes, whats your issue..... | Does any one wave solder the 0402 Chips on the bottom side of a board? | Any comments?
