Electronics Forum | Sun May 25 10:30:31 EDT 2008 | necdetozyonum
Dear All, I would like to take your opinion about the result that we have faced after cleaning the PC assemblies in a cleaning machine (Miele Dishwasher) with the cleaning detergent Qualitek Everkleen 1005. We use DI water for cleaning purpose in t
Electronics Forum | Fri Jun 24 04:51:38 EDT 2016 | unix60959
Hello, Does anyone know where I can find any information or documentation on the miniwave height sensor and control. I feel like the company I'm working for is possibly using the machine incorrectly in this regard. I assume, but would like to verify
Electronics Forum | Fri Feb 09 10:56:26 EST 2007 | realchunks
Sure is. It's called Dual Pot. Most major wave solder manufactureres offer it. The quickest way is to buy a used wave for Pb and keep your existing Pb free wave, Pb free!
Electronics Forum | Thu Jun 07 08:35:11 EDT 2007 | samir
So you are saying that, for a CHIP wave (not the smooth, laminar wave), but the CHIP wave, your expectation is to see "smooth" solder, and not ripply, turbulent solder. This is what you're saying, correct?
Electronics Forum | Sat Jan 18 12:44:35 EST 2020 | anteiv
We made much better contact of wave with board. There was not enough solder in bath. We increased it so wave height is higher with same pump power And now board is pushing dirty wave to the other side and board is much cleaner!
Electronics Forum | Fri Oct 09 14:01:24 EDT 1998 | Bob Barr
Charles, I am using an Air-Vac PCBRM12 to selectively solder a 96 pin thru-hole connector onto an otherwise all SMT board. Cost is $8.6K plus about $300 per flow well (nozzle.) Went from a 6 minute cycle to hand solder the connector to 15 seconds o
Electronics Forum | Wed May 02 10:37:59 EDT 2007 | DG
We have 4 EVS machines in our facility. The operators like them, maintenance doesn't. The PM's aren't that bad it just that maintenance doesn't like doing them. On a few of the earlier machines we have if the operators are not careful they can get mo
Electronics Forum | Mon Jul 14 16:29:57 EDT 2008 | patrickbruneel
Stephen, Correct when focusing just on contact length and time only contact time should change when changing the conveyer speed (when the machine is in good operating condition). Changing the conveyer speed changes a lot more parameters like: *Flu
Electronics Forum | Fri Oct 24 20:53:53 EDT 2003 | pranav
I am re-designing a MLB Printed Circuit Board which has thro' hole chips and a BGA. I am planning to go for reflow soldering for the BGA on one side and wave soldering for the thro' hole parts on the opposite side. Is there any concern or any sequenc
Electronics Forum | Tue Mar 08 19:37:17 EST 2011 | Jacki
Hi We did some evaluation to solder 0.4mm pitch by Wave. We found that there were many solder shorts at Sockets pins so it made touch up time longer. Please advise me someone has achieved the fine pitch soldering by wave. Thanks in advance.
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774
