Electronics Forum | Wed Oct 23 08:24:57 EDT 2002 | pizz
I want to know how many PTH or DIP components is the critical point,when we choose the process,two side reflow or one reflow other wave soldering? it is not easy to make decision ,the cost of the hand soldering is cheap in our country. any comments w
Electronics Forum | Tue Nov 26 15:16:30 EST 2002 | GSW
Hi, Anybody apart from the solder manufacturer themselves or their distributors who have used this alloy for lead free wave solder ?
Electronics Forum | Wed Dec 18 11:59:18 EST 2002 | russ
We sometime use a temporary solder mask to "glue the parts down" if bean bags don't work Russ
Electronics Forum | Mon Dec 23 11:12:36 EST 2002 | gswable
Hi, Can anybody help with a DOE for water soluble flux selection for a wave soldering process? Looked in threads but nothing specific. hav test wehicles and a waaev machin with melt solder in that T
Electronics Forum | Wed Jan 22 14:14:56 EST 2003 | Stephen
Most of the design considerations will be for the wave soldering of the SMT parts. Have you considered selective soldering pallets or masking as an alternative? One problem I have seen with the epoxy process is parts that are high off the board and t
Electronics Forum | Wed Jun 18 10:42:07 EDT 2003 | caldon
Frank- Dreamsniper touched on something I totally forgot about....DROSS.....This is a subtle way for $$$$ to be lost. If it is silver and Shiney...it does not belong in the dross recycle bin. That is good Solder being tossed. You can also add into
Electronics Forum | Mon Oct 27 09:47:39 EST 2003 | yiannis
hi, Are there users of Aura - a wave soldering machine of Automation ?. I d like to buy a copy of the manuals and to ask a few questions. Thanks
Electronics Forum | Tue Dec 16 19:45:47 EST 2003 | Hiram
Hi, I am looking for the IPC criteria hole-to-lead ratio. Does anybody know a practical way to determine if some holes in my pcb's do not get enough solder in the wave solder machine because an inapropiate hole-to-lead ratio? Thanks in advance! Hi
Electronics Forum | Mon Jan 26 11:41:04 EST 2004 | pbarton
Some questions: Is the peelable/spot masking only being applied to the earthing points on the one side or to both sides? Is the peelable mask you are using specifically designed for coating masking or is it the same as that you use for masking sold
Electronics Forum | Fri Mar 12 11:41:53 EST 2004 | pjc
Don't detach the bead and don't twist the wires! The bead should be what makes contact with where you want to measure temperature. Tape is not the ideal method to attached thermocouples for reflow soldering but is OK when using for wave solder prehea
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477