Electronics Forum | Fri Jul 21 16:34:56 EDT 2006 | kris
and also that most connector/PTH component vendors test their components with immersion temperatures of around 260 degc & they do not preheat the components, so it does not mimic the heat in a typical wave soldering operation
Electronics Forum | Thu Aug 24 12:09:35 EDT 2006 | Chunks
Now how did you know we were wave soldering BGAs onto a board that goes into a karaoke machine? Thanks for everyone's input. We currently use tacky flux, but I beleieve we will also look into screening paste onto the BGA as well.
Electronics Forum | Wed Oct 11 16:24:10 EDT 2006 | ThermPro
Hello James, The most cost effective system you could buy is an offshore manufactured system. Most of the technology is the same, as well as, the design and construction as the big brands. Take a look at http://www.thermproeng.com Regards, Sea
Electronics Forum | Wed Feb 28 15:15:49 EST 2007 | JMW
The BEST cost effective system you could buy is slightly used. Take a look at http://www.jmw-inc.com/
Electronics Forum | Mon Oct 02 17:33:24 EDT 2006 | russ
nope it will not, I am sure that an FR-4 board has been wave soldered sometime in history Russ
Electronics Forum | Thu Oct 12 12:37:27 EDT 2006 | pegasus59
MY PARTS SUPPLIER PRICES SEEM HIGH FOR PARTS FOR MY WAVE SOLDER. I AM LOOKING FOR AIR STONES FOR THE FLUX. ANY BODY HAVE OTHER OUTLETS I CAN LOOK IN TO?
Electronics Forum | Mon Nov 27 16:38:23 EST 2006 | billwestiet
Greg, I'm intrigued. Where have you had a chance to install and support over 250 machines? Thanks for the tips, we'll try this out.
Electronics Forum | Mon Nov 27 17:14:50 EST 2006 | russ
That must have been what the conveyor angle was on the machine they copied, remember that the Chinese do not know the engineering on equipment only how to "copy it" Russ
Electronics Forum | Wed Mar 07 14:00:28 EST 2007 | slthomas
There sure have been a lot of advocates for Asahi surfacing today. Call me suspicious, but this might be a good time to suggest IP tracing on the new forum hosting system.
Electronics Forum | Wed Apr 04 16:54:58 EDT 2007 | pjc
Maybe more baking time is needed. Topside board temp too low. Moisture trapped in board. Top of through hole capped by component and trapping flux. http://www.speedlinetech.com/electrovert/electrovert-troubleshooting/index.htm
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477