Electronics Forum | Wed May 26 15:56:08 EDT 1999 | Chrys Shea
| | | we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any
Electronics Forum | Tue Jun 08 12:49:41 EDT 1999 | Dave F
| Hi,my master | How to iron out such soldering bridge with below conditions: | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | 3.using spraying fluxer and n
Electronics Forum | Tue Jun 08 13:06:53 EDT 1999 | Kevin Hussey
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Tue Jan 23 20:53:51 EST 2001 | davef
Sorry, not much help for me there. More information would be helpful. For instance: * Talk about the distribution of the problem, including a single lot or from various lots and over components and component types on the board * Tell us about the boa
Electronics Forum | Mon Mar 12 13:57:50 EDT 2007 | davef
That your problem is not related to component solderability or wave process related makes us believe this has to do with bare board design. Look at how your designer did the thermal relief on the two pins that don't solder well. If you can't get a
Electronics Forum | Mon Mar 02 13:06:36 EST 2020 | charliedci
If you add any "flux cored" wire solder to the pot make sure you have ventilation as the flux will burn off and smoke like crazy. This solder pot is like any used in a wave or selective solder, no flux. The flux is added to wire prior to di
Electronics Forum | Tue Nov 09 17:26:13 EST 1999 | Dave F
Horace: You weren't real specific about the set-up of the two machines. So what's the diff man?? Big dross generators are: 1 R Woodgate says that pump speed is the biggest driver to dross production 2 Chrys uses low dross cast bar: Alpha HiFlo 3
Electronics Forum | Wed Oct 12 20:53:44 EDT 2005 | mderen
We are currently wave soldering connectors that are held in place by stainless steel screws. About 20% of these screws emerge from the process with varying quantities of solder attached to them. We have just had our solder bath checked and no impurit
Electronics Forum | Mon Jan 11 14:48:44 EST 2010 | davef
SR1000 is commonly used for tenting. Search the fine SMTnet Archives on : tenting Someone gave us this note. We have lost their name. It seems to be good advice. If Liquid Photo Image (LPI) solder mask is required, do not tent via holes. Tenting
Electronics Forum | Wed Feb 21 08:48:37 EST 2007 | rgduval
Ideally? Never. You risk component break down by re-running the board over the wave machine. In a perfect world, your wave operator would make adjustments after one run, and you'd run another panel over the wave to judge the effectiveness of the a
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437
