Electronics Forum | Tue May 04 14:45:40 EDT 2010 | bruna
Hello Does anyone can give feedback about this two analyzers (zirox and delta f 150)? In fact we are trying to understand which is better for wave soldering, benefits and prejudice. Does anyone work with both? Thanks
Electronics Forum | Wed Aug 04 16:30:44 EDT 2010 | dldavis
We are using a Propyl Bromide vapor degreaser solvent. Has anyone heard of this solvent when used near an oven will decompose and cause major corrosion to metals such as in a Reflow oven or a wave solder pot?
Electronics Forum | Thu Aug 26 03:58:32 EDT 2010 | jacki
Hi all Did anyone encounter that the thermal crack failure or any failure issue by using the Kemet Ceramic Cap, particularly 0.1uF,while wave soldering? Before using this part, I want to clarify whether it is suitable for our process or not. Thanks i
Electronics Forum | Wed Sep 22 09:58:45 EDT 2010 | mb_mfg
We’d be more than happy to take a look and your pallet(s). Depending on what is needed to make the pallet working properly, would determine whether anything can be done with it.
Electronics Forum | Fri Apr 22 14:19:29 EDT 2011 | cbeneat
Patrick, It actually seems to go away after every adjustment. Whether it's flux, heat, doesn't matter but it always reappears. The part that has me baffled is the fact that another identical part is approx. 4 mm away, and never affects this one.
Electronics Forum | Wed Apr 27 08:41:03 EDT 2011 | cbeneat
Larry, The early results are in and turning the fixture, as you recommended seems to have fixed the problem, I want to thank everyone for their input, if this turns into another temp. fix I'll be back. Stay tuned!
Electronics Forum | Thu May 12 11:28:58 EDT 2011 | cbeneat
I believe so...the last 100 or so boards we ran gave us no problem, we haven't ran any since. Easy fix, thanks again.
Electronics Forum | Thu Aug 04 09:32:03 EDT 2011 | rway
No need to clean unless the sticky residue is an issue for you. If you are working with RF, it could be an issue. You may have probe contact problems as well with ICT and FT fixtures. We use a low residue flux for our wave solder machines (Kester
Electronics Forum | Wed Aug 24 10:24:33 EDT 2011 | bobsavenger
Yeah, we use the Mole also for setting up a new build but I was wondering about a quick validation. Thanks for your input.
Electronics Forum | Wed Oct 12 07:18:51 EDT 2011 | babithak
My requirement is to clean flux from PCB after wave soldering. I found information that TCE is harmful to enviroment and human health. But my doubt is that is it harmful to electronic components in any way. Does it cause failure of electronic compon