Electronics Forum | Tue Nov 22 10:36:23 EST 2005 | maforni
Does anyone know if there are specific tools designed to remove fingers from the wave solder rails? Thanks
Electronics Forum | Fri Nov 25 09:34:31 EST 2005 | davef
What does your equipment manual suggest as the proper method for removing fingers?
Electronics Forum | Thu Jan 13 12:07:24 EST 2000 | Tony Nirchi
Gold finger connector over a wave solder, what would be the best way to protect the fingers from solder.This is a high volume job.
Electronics Forum | Mon Jun 22 21:46:33 EDT 1998 | Dave F
| I am looking for alternate suppliers of Hollis wave solder fingers other than Speedline(Electrovert) The Model and S/N of the wave solder is | Model 207944 | Serial # F11132 | Please let me know if you are a vendor or know of a vendor. Your help w
Electronics Forum | Fri Jun 19 14:57:00 EDT 1998 | Chris Jackson
I am looking for alternate suppliers of Hollis wave solder fingers other than Speedline(Electrovert) The Model and S/N of the wave solder is Model 207944 Serial # F11132 Please let me know if you are a vendor or know of a vendor. Your help would be
Electronics Forum | Tue Jun 23 17:03:10 EDT 1998 | Ken Chase
Yes, New Era Technology, Inc. is a manufacturer of Titanium fingers for Hollis and Sensbee wave Solder machines, as well as a other products. give them a call @ (603)669-7971 for more info.
Electronics Forum | Fri Jan 14 09:36:49 EST 2000 | Richard
If the gold fingers are pad types which plug into expansion slot connectors, I have used a titanium guard attached to the wave conveyor over the solder pot, which allows the PCB to connect to the fingers but masks the solder from the gold pads along
Electronics Forum | Fri Jan 14 15:02:16 EST 2000 | John Thorup
Second the motion for the Stevens Products covers. They call them Gold Fingers Gloves and they are a pull-truded fibreglass product that comes in sticks. You hacksaw them to the length needed. We have many that have been through the wave thousands o
Electronics Forum | Sat Jan 22 01:56:54 EST 2000 | Hany
HI Tony: We have the same case last month & we tried to fold a little sheet of metal (stainless steel I guess)on the fingers edge & it has worked perfectly. Only one fault among more than 1000 Pcs & it was referred to a manual error. You can try it,
Electronics Forum | Thu Jan 13 12:36:09 EST 2000 | Wolfgang Busko
Tony: Have a mask applied by the boardhouse which can be removed after soldering. We worked with pallets or tape but had bad luck with some boards. At present I would prefer a mask. M2C Wolfgang
