Electronics Forum | Thu Mar 09 12:31:46 EST 2006 | jsloot
I am experiencing peel back problems when a particular component is used on a Meridian 1010 and 1020P machine. I would like to start testing this force but I need some more info. Besides GPD who else makes a tester? What industry standards can I refe
Electronics Forum | Thu Feb 21 10:11:36 EST 2013 | patrickbruneel
The backflow in the wave started to become very important with the development of no-clean/no residue fluxes. These fluxes don’t have (or at least shouldn’t have) rosin, resin or other vehicles in the formulation which encapsulate surface oxides from
Electronics Forum | Thu Jul 10 12:56:46 EDT 2014 | clydestrum
VERY interesting. Thanks, folks. I will look into this.
Electronics Forum | Sun Jun 29 07:31:03 EDT 2014 | vitrost
Hi, We had experienced very similar issue on boards of a certain PCB manufacturer. Field experiments showed that the solder mask of this manufacturer is prone to swelling and peeling after it was in contact with our water-based flux. When you switc
Electronics Forum | Fri Jul 04 06:49:41 EDT 2014 | padawanlinuxero
Hi We had the same problem but it turns out the problem is with the supplier we use a water base flux too, supplier change the solder mask and it work. cheers!
Electronics Forum | Wed Jun 04 11:09:06 EDT 2014 | clydestrum
Ok, I have an issue that is somewhat uniform in it's recurrence in that it keeps showing up on the same location on the board. The problem area is a group of traces on the exposed side, that keeps having solder mask peel occur. As you can see in the
Electronics Forum | Thu Sep 07 10:13:42 EDT 2006 | davef
Contact peel force equipment manufacturers, tell them what you want to do, and ask them for the contact information of their customers in your region. Some prominent peel force equipment suppliers are: * RVSI/Systemation TP-150 * EPI PTS-2001 * GPD
Electronics Forum | Thu Aug 31 16:18:30 EDT 2006 | GS
I beg you pardon AR, I made a mistake by reading your request, you are looking for a service lab who can do the peel back force test and not the Reference Standard (like EIA-481) for T&R. You should check if in your Country some Tape and Reeling Serv