Electronics Forum | Wed Mar 03 12:01:08 EST 1999 | Dave F
| I'm trying to get a feel for what the industry is doing with regards to collecting assembly defect data in the SMT/PWA process. Is it sampling or 100%? What are the points within the process where critical assembly defect data is collected. We run
Electronics Forum | Tue Feb 23 11:09:12 EST 1999 | Steve Gregory
Hi Dave! Dat' be da same board we ran at NEPCON East in 97'! Ray Rua was running the TAC line then (his company usually runs the TAC line at almost all NEPCON shows). A couple of things I wanted to point out on that GIF image that might b
Electronics Forum | Thu Jan 28 14:10:57 EST 1999 | Tom B
Hello Netters, I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that the LPI solder mask
Electronics Forum | Thu Jan 28 15:43:16 EST 1999 | Dave F
| Hello Netters, | | I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that the LPI solde
Electronics Forum | Sat Jan 23 16:07:20 EST 1999 | Steve Gregory
| hi, | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier proces
Electronics Forum | Fri Jan 22 18:54:54 EST 1999 | Steve Gregory
> If you are inheriting a system, you probably don't have a lot of choice, >>but with a little ingenuity, you can pull a Steve Gregory: Grab some duct >>tape, a book of matches, and a videotaped rerun of MacGyver for >>inspiration. HEY! Whaddya mea
Electronics Forum | Fri Jan 15 11:33:46 EST 1999 | Bob Willis
| Hello, | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | So far, the tests I can think of performing, and that we have
Electronics Forum | Tue Jan 12 10:18:36 EST 1999 | Russ Steiner
| Any idea what the "industry standard" is for fall out on assembled PCB's? I realize that the controls put in place in your processes will effect your overall quality. But I'm trying for a general answer. On pre-tested assemblies, should you exp
Electronics Forum | Tue Jan 05 18:07:53 EST 1999 | Dave F
| I am looking for information regarding post wave soldering of stranded wires into a circuit board using OA core wire solder. We do a final pass thru the cleaner after the hand soldering but I'm concerned about any OA flux residue that may have wic
Electronics Forum | Tue Dec 29 12:57:08 EST 1998 | Earl Moon
| Does anyone have angles on how to reduce N2 consumption at reflow process (i.e. process control equipment, etc.)? | | Any help would be appreciated | N2 consumption is very "machine" and process dependent. Some machine designs are better equipped