Electronics Forum | Fri Apr 09 09:08:40 EDT 2010 | cast2010
Hello, I produce two types of board. - 100% Thru Hole - 50% thru hole and 50% SMT For the second, I have a bad wetting after the reflow on the top. The pcb board have Au-Ni pad. I use a water soluble paste. I clean the board with a solution with
Electronics Forum | Mon Sep 13 22:32:41 EDT 2010 | genesan
Hi all good morning and need advice from expertise here. One of my customer complain that they have constantly issues with one of their product and ask us to do cross section.The report show there was “no wetting to the PCB copper pad” and cause the
Electronics Forum | Mon Sep 13 22:58:49 EDT 2010 | genesan
Hi all good morning and need advice from expertise here. One of my customer complain that they have constantly issues with one of their product and ask us to do cross section.The report show there was “no wetting to the PCB copper pad” and cause the
Electronics Forum | Fri Sep 17 03:03:29 EDT 2010 | grahamcooper22
Hi Gani, looking at the HASL icture and the poor wetting of the solder over the pads I would imagine that the HASL coating is very thin on the pads and in actual fact isn't 'solder' but is tin /copper intemetallic and this has poor solderability. It
Electronics Forum | Thu Mar 22 13:06:50 EDT 2012 | smtmfgeng
Does anyone have any insight on alternatives to Indium NC-SMQ 92J solder paste for minimizing poor wetting on parts with oxidized leads (see datasheet here: http://www.dtsprocess.com/contents/articlefiles/6-SMQ92j.pdf). I am considering setting up a
Electronics Forum | Fri Feb 15 14:38:59 EST 2013 | bmario
Hi, We are having a problem with the interpretation of the surface evaluation criteria of J-STD-003 section 4.2.2.4.2. "A minimum of 95% of each of the surfaces (i.e. each pad) being tested shall exhibit good wetting. The balance of the surface may
Electronics Forum | Tue Mar 25 13:55:05 EDT 2014 | horchak
Ok lets put it this way. If the PCB house used a high quality mask and properly applied it to a properly cleaned surface and properly cured it, then as Dave stated above there are only two things that can destroy it. Excessive heat and overly aggress
Electronics Forum | Thu Apr 17 13:37:11 EDT 2014 | anvil1021
Hello All....we have several hundred PCBs that we need to run with a no-clean solder process and the surface finish is OSP. Our preliminary testing has found that the solder will not wet the entire pad even if the pad is over printed? We have contact
Electronics Forum | Fri May 30 20:03:14 EDT 2014 | hegemon
Starting with the manufacturers layout is a good start. Tilted parts, bad solder joints, sounds like a wetting issue and the board or the parts. Insufficient solder sounds like the printing process needs some attention. We have used this part in th
Electronics Forum | Thu Aug 10 11:24:18 EDT 2017 | dleeper
The exposed metallization on the sides of the QFN probably aren't tinned and therefore not expected to have solder wetted to them. If previous parts formed nice toe filets, it might just be that those parts were fresher and the exposed metal did not
