Electronics Forum | Thu Apr 17 05:14:40 EDT 2008 | gregoryyork
I have seen similar things like this before with Solder Resist redepositig back on the pads, this is a clear residue very hard to see. Solder resist will obviously resist solder adhering to it. If you rework the boards then the heat of the iron will
Electronics Forum | Mon Aug 17 02:57:47 EDT 1998 | Bob Willis
| | Looking for Suppliers of surface mount wetting balance equipment. | Bucky: Section 6 of the ANSI/J-STD-002 specification lists wetting balance suppliers. Dave F I like and continue to use the Multicore system. I have had many ours using the sys
Electronics Forum | Tue Dec 04 10:30:16 EST 2007 | slthomas
Q: The question I have is do they wet in wave solder, and if they do, why does it matter what happens to them in reflow? A: Yes, but somebody here don't agree with me that the glued part need help from wave to get the good wetting. They are wrong
Electronics Forum | Wed Feb 22 03:29:09 EST 2017 | niki
Which is the best way to clean the PCB after > soldering? Is it good enough with IPA > (isopropyl) or with the Flux Remover > spray? However, we use a lead free solder wire > (3,5% flux inside the core) and after the > soldering its a visible we
Electronics Forum | Tue Jun 29 16:03:57 EDT 1999 | Dave F
snip | John and Dave, | | Again, I don't work with larger chip devices with this issue. The company I now work with developed a strategy, based on considerable research (as others of us did in the past), to do things like placing 0603's on 0402 pad
Electronics Forum | Fri Mar 12 20:19:46 EST 1999 | Dean
| AVX and a few other companies make these chip transient voltage suppressors (TVS) parts that are a real *PAIN* to use. According to AVX: | "Due to the semiconducting nature of the doped Zinc Oxide (ZnO) ceramic material, SMT TransGuards ar
Electronics Forum | Mon Oct 12 08:07:45 EDT 1998 | Earl Moon
| I have datas to substain that a not wetting PCB ( the HAL oxided or not uniform in thickness )if soldered in reflow, it shows voids with X-Ray inspection.The voids are in side all the joints not only on the solder pads levell. | | Is there a techn
Electronics Forum | Mon May 12 17:59:55 EDT 2008 | rgduval
We're currently experiencing a spate of solder not wetting to pads of PCBs, and it's becoming more aggravating on a daily basis. At this point, we're running out of ideas. I've searched the Fine Archives for information, and, so far, haven't found
Electronics Forum | Fri Sep 25 12:26:34 EDT 2009 | clampron
Some information on the web regarding RoHS and tip life... What problems are there for using Lead-free solder? ? Higher melting point of Lead-free solder may cause physical and thermal damage to components and PCB. ? Lead-free solder has poor
Electronics Forum | Thu Sep 15 10:43:18 EDT 2016 | claudea2
Thanks to Bobpan we re connected our wipe system and all the air actuators work fine. I still have a problem with the cleaner fluid dispenser. It is not moving as it should to dispense the liquid when we do the command. I suspect the values in the c