Electronics Forum | Mon May 15 20:02:14 EDT 2000 | Dave F
Marlin: So, what's with the folks at Vitronics? Why can't they email you the files you need? Dave F
Electronics Forum | Wed May 10 06:21:59 EDT 2000 | GOLI
I have been tasked to evaluate the performance of 0201 capability of machines. I trying to find out what kind of paste and stencil design most suited for the task. Does anyone share their experiences with 0201 components?
Electronics Forum | Thu May 11 09:35:21 EDT 2000 | C.K.
Wow, after 27 holes, and buzzed, you still manage to surf the SMTNet forum - from home of all places! What a dedicated hard core SMT warrior!!
Electronics Forum | Thu May 11 18:24:12 EDT 2000 | Micah Newcomb
placement is only ok?, what size chip is this? Is the pad spacing correct? Are the apertures on your stencil reduced or 1:1. Stencil thickness? Do the problem areas heat up evenly? special plating on terminals of cap? Need more info.
Electronics Forum | Sat May 06 08:05:31 EDT 2000 | Dave F
Charles: I don't know about machines doing what you're talking about, but I sure I know that I do!!!! Good luck. Dave F
Electronics Forum | Wed May 03 21:07:36 EDT 2000 | Eric Chua
Hi Steve, I had face problem before. What I did, add addition process which is screen print that apply adhesive. During thru-hole assemble, the components hold strong by the solder. Try this.
Electronics Forum | Mon May 08 16:56:00 EDT 2000 | Peter van den Berg
Thanks Dave, we already use zero ohm resistors. What we're looking for is a flexible (bendable) jumper.
Electronics Forum | Fri May 05 14:32:14 EDT 2000 | C.K.
I read my posting again, and it didn't sound right....what I meant was slow down your conveyor speed BY .5 to 1 FPM. So, if you're running @ 4 FPM, slow it down to 3.0 to 3.5 FPM.
Electronics Forum | Fri May 05 14:44:35 EDT 2000 | Kal Chakraborty.
Hi Ashok, Is there any rework process on those assembl./PWB ..if yes --what kind of tools are your operators using now ...brush? spudger? cloths (is it lint free?) ect. I hope you are not talking about nodules in the hole barrel. Regards Kc.
Electronics Forum | Mon May 01 13:30:45 EDT 2000 | JAX
Erhard, I am not sure what you mean. I believe bulk case placement only refers to C's & R's. Even then placing only 0603 and 0805. I assume you are talking about larger parts since you mention trays???