Electronics Forum | Mon Mar 28 09:56:36 EST 2005 | n wolford
We have a granite table out on our production floor. We use the table along with metal parallel bars and a height gauge to measure component height. Some of these boards have components on them that may be ESD sensitive. Does anyone have experience w
Electronics Forum | Mon Apr 04 18:23:35 EDT 2005 | GS
Solder volumes is very important parameter to keep under control in order to get a good and reliable CCGA solder joint, and an automatic 3D paste volume inspection is strongly recommended practice to use. Questions: - what Column pitch do your CCGA h
Electronics Forum | Mon Apr 04 09:35:16 EDT 2005 | russ
What are the max temp specs for each of the components? this sounds like the real problem with lead free conversion. Which parts are which? Currently we are getting ready to reball lead free BGAs back to lead for a customer that had to be lead free
Electronics Forum | Mon Apr 11 04:41:05 EDT 2005 | Grant
Hi, Yes, I think that's what he needs. Something that does fine pitch placement, but could also do faster chip shooting if required. Just a fine pitch placer might be too slow, but if he's only doing proto's then it might be ok, as time would be be
Electronics Forum | Thu Apr 07 10:58:01 EDT 2005 | Dhanish
Need help from the experts on 1)simple way to measure the PCB warpage 2)what is the maximum warpage can the SMT machine allow the to accept and place the component without problem. 3)I have seen some people are using 7mils/inch as a Warpage spec. a
Electronics Forum | Fri Apr 08 17:23:34 EDT 2005 | KEN
Warpage factors can cause: 1. Boards can not transfer down conveyor belts or wedge at transitions. 2. May not enter into machinery due to interferences (like board clamps) 3. May fall off conveyor chain in furnace. Especially true of thin (PCMCI
Electronics Forum | Thu Apr 07 19:30:09 EDT 2005 | chrispy1963
Hi there To all the MyData users out there who use Agilis feeders I would like to pose a question. What does your company do with the feeder sticks you have that get the tips of the plows broken off? Do you get them repaired or do you toss them aw
Electronics Forum | Fri Apr 08 13:55:05 EDT 2005 | chrispy1963
Grant, Yes they do get broken by the operator or whom ever is loading or unloading the feeder stick pulling the tape through the feeder and the component pocket will snag the tip of the plow and bend it so that the tip ends up breaking off making
Electronics Forum | Wed Apr 13 15:21:25 EDT 2005 | mmjm_1099
Thats called technician syndrome (fine when your there and bad when you walk away). Is someone inspecting the board before reflow? If so make sure they don't touch it and run about 5 boards and see if it's consistent for placement. What type of pro
Electronics Forum | Thu Apr 14 05:20:58 EDT 2005 | aj
All, I am considering trying out the above to try and eliminate some of my defects on the wave process aswell as reducing cycle time etc. Incase of unfamiliarity with what it is : basically there is a Solder Preform present on the Header/Connector a