Electronics Forum: where to get (Page 1 of 276)

where to get good flux

Electronics Forum | Sat Apr 06 10:36:40 EDT 2013 | ericrr

this is on a repair when I add more paste, I am sorry I asked

where to get good flux

Electronics Forum | Tue Apr 02 13:27:41 EDT 2013 | ericrr

So where does one get good flux? the engineers had a little bottle of good flux that the owner of the company liked, it had a oily feel to it. So then the company purchased some more since the engineers look like it was about to run out, the owner of

nozzles, where to get them?

Electronics Forum | Wed Jan 19 10:02:55 EST 2000 | g cronin

has anyone had any good experiences with purchasing replacement nozzes for pick and place, chipshooters, from a supplier other than the original manufacturer? I know of a couple that currently sell aftermarket replacement nozzles at a very reasonabl

where to get good flux

Electronics Forum | Tue Apr 02 14:24:35 EDT 2013 | hegemon

Too many hands in the bucket, unless the owner is one of the engineers. Typically flux is not rated or classified by "feel". What are you soldering? Wires? Components to PCB? What is your cleaning capability or requirement? Aqueous? No-Clean? Ul

where to get good flux

Electronics Forum | Wed Apr 03 04:08:20 EDT 2013 | ericrr

Yes well, now we used to add a bit of flux to our leaded paste to make it slightly runny, But when we went to unleaded paste the joker who came in from another company to set the temperature on the oven said "you dont add anything to unleaded paste!.

where to get good flux

Electronics Forum | Wed Apr 03 19:03:31 EDT 2013 | hegemon

In agreement, in that you should have already printed enough paste on the board to accomodate the joint. Adding paste would give the result you described. (too much solder) Adding a little flux (only) and heat would be the correct path out of that s

where to get a pot coated

Electronics Forum | Tue Feb 21 11:35:23 EST 2006 | alandra516

Call me I can get it done for you. Glenn @ 903-892-5636

where to get a pot coated

Electronics Forum | Wed Feb 22 08:52:29 EST 2006 | russ

Any details?

where to get a pot coated

Electronics Forum | Wed Feb 22 09:54:34 EST 2006 | russ

thanks slaine!!

where to get a pot coated

Electronics Forum | Tue Feb 21 10:51:55 EST 2006 | russ

Does anyone know of a source to get an existing stainles solder pot coated to handle Pb free?

  1 2 3 4 5 6 7 8 9 10 Next

where to get searches for Companies, Equipment, Machines, Suppliers & Information