Electronics Forum | Tue Apr 16 05:05:32 EDT 2013 | stivais
We recently had a discussion with customer's QM - he claims that calculations for a proper solder wire diameter and soldering iron tip size (and temperature) have to be performed and documented for all manual (T/H) solderings (based on component size
Electronics Forum | Mon Jul 10 07:46:51 EDT 2006 | ronalds
You are right, RSS profile is not the correct description. I am using a profile which heats up quickly to let the flux spread. Next linear up to activate the flux and prevent thermoshock. My experience is however, that small changes in this profile
Electronics Forum | Mon Dec 17 19:01:45 EST 2007 | bbarton
As someone with a LOT of experience with the "low cost" alternative alloys, primarily SACX, I have one simple question....Are these shorts a new phenomena? WAS your process in control, and all of a sudden it's not? If the answer is YES, take a look a
Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Mon Jul 07 09:47:50 EDT 2008 | davef
Dye & pry test reveals the solder connections that have failed prior to performimng the test.
Electronics Forum | shellydhami |
Sat Jul 05 14:04:31 EDT 2008
Electronics Forum | Fri Jan 29 11:23:54 EST 2010 | ppwlee
Smtnet, I am looking at pros and cons for automated soldering. The application is a simple multi pin through-hole soldering on a high volume manual assembly line. The goal was to eliminate defects associated with missing solder pins which goes undet
Electronics Forum | Tue Dec 03 18:31:45 EST 2002 | slthomas
At the price of Durapol we'd never get the OK to have them made. The Al fixtures are cheap and a quick turn local item. As dense as the pth parts are I also don't think there'd be any room for any holes which I really think is the answer as far a
Electronics Forum | Tue Dec 10 14:10:38 EST 2002 | Randy Villeneuve
Steve, I wave solder most if not all our boards with selective wave pallets. I did not catch if the solder balls were on top of the board or on the bottom but that will make a difference on what to do to get rid of them. Pallets are good and bad. On
Electronics Forum | Thu Feb 12 16:42:33 EST 2015 | hegemon
I can only speak for Mirtec and Yestech AOI for SMT Solder Inspection. We do use Koh-Young AOI for Solder Paste Inspection. As usual ,you need to identify exactly what it is you are trying to achieve with your AOI, if you are just trying to fill a