Electronics Forum: wire (Page 11 of 130)

Criteria for thermocouple wire attachment

Electronics Forum | Thu Dec 21 22:13:37 EST 2006 | davef

Look here: http://www.smtinfo.net/Db/_Thermal%20Profiling.html

Criteria for thermocouple wire attachment

Electronics Forum | Wed Dec 27 18:35:07 EST 2006 | SWAG

Look just above the toaster oven in the last picture - these guys have a chipshooter, too!

Criteria for thermocouple wire attachment

Electronics Forum | Tue Jan 09 04:32:58 EST 2007 | d0min0

Hello everyone, any estimation how many (minimum)thermocouples on board, how to calculate this ? regards

Electrical Wiring Anomaly

Electronics Forum | Wed Nov 09 11:41:56 EST 2011 | swag

The water source is D.I. water.

Electrical Wiring Anomaly

Electronics Forum | Wed Nov 09 17:45:39 EST 2011 | swag

Thanks for the input. We'll take look at that.

Floor Wire less strap

Electronics Forum | Mon Apr 19 07:22:11 EDT 1999 | Hunter

Dear all Considering Anti static precautions? 1-Do we need to add a layer of ...say . Epoxy for the floor in our factory? provided that .The current floor is hard top concrete of 250 Kg/cm2. 2- Anti body heared about Wire less Hand strap Some body to

Re: Stripping Magnet Wire

Electronics Forum | Thu Jul 15 22:40:43 EDT 1999 | Dave F

I need a good chemical to remove the lacquer finish off of magnet wire. I know there are different kinds but I need one that really works. Any suggestions would be great. thanks in advance guys. Jeff: Scott's correct. Buy a mechical stripper f

Wire for PCB modifications

Electronics Forum | Thu Jun 14 21:43:17 EDT 2001 | davef

I know this isn't what yer asking about, but this stuff is so coo [http://www.intertronics.co.uk/products/cpreleg.htm]. We just screw a U shaped tip on the iron and go!!! Preleg Inc [Rework wire # 210302] 524 Paul Morris Ave., Ste. E Englewood, FL

Aluminum wire bonding

Electronics Forum | Sun May 26 10:21:46 EDT 2002 | V.RAMANAND KINI

We buy PCBs for aluminium wire bonding. Our PCBs have 0.25 mm square pads for bonding and 0.10 or 0.15 mm gap between circuit traces/tracks. We do not have any problem. Our vendor gives 9 microns of Nickel and 0.03 microns of gold.

Jumper Wire Assembly Aids

Electronics Forum | Thu Mar 04 09:39:22 EST 2004 | Ron W

Counting leads to attach jumper wires, especially on large, fine pitch quads can be quite a challenge. Is anyone aware of any kinds of assembly aids that would assist in this process? I was thinking of inspection templates with the particular lead(s)


wire searches for Companies, Equipment, Machines, Suppliers & Information