Electronics Forum: wire (Page 36 of 130)

Internal Oven Calibration

Electronics Forum | Mon Feb 13 22:26:30 EST 2006 | KEN

You are correct. Regardless of what any auditor is asking what we're dealing with here is sound science and good Process Engineering. Standard methods for temp profiling are not absolute. If you are using a Temp simulator you are only verifying th

Professional Soldering?

Electronics Forum | Sat May 07 13:09:14 EDT 2016 | embidd

First off, let me say hi to everyone in the forums. This is my first post but hopefully not my last. Okay, so the other day I decided to take my graphics card apart, and in doing so I clipped one of the wires that connect the fans to the fan header

College can't make SMT PCB's

Electronics Forum | Tue Dec 11 20:15:36 EST 2001 | mparker

What happened to good ol' 30 ga. hook up wire? I used to be a whiz with a wire wrap gun. I've even hand soldered wires to a 240 pin QFP (the Engineer was too cheap to buy a $80 socket). Just what are they teaching in these edifices of matriculation

Fuji CP3 R FENCE Problem

Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz

Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee

Conformal coating rework jumpers

Electronics Forum | Sat Oct 08 11:57:58 EDT 2016 | davef

A friend in the contract coating business said: "... ask why the wire is [teflon] coated in the first place, as only the solder joints should be coated in this situation as the flexing/bending of the wires will cause the coating to crack and flake of

Soldering robot and solder balls

Electronics Forum | Mon Jun 26 08:57:17 EDT 2017 | capse

If N2 is not an option, the cut wire feeder or drilled wire are your best bet for now. You need to optimize wire feed rate as well. The solder joint on the robot takes about the same time to form as in manual soldering. If you need to speed the solde

Dek Printer 265Lt - Vision hardware error

Electronics Forum | Tue Feb 12 01:14:46 EST 2019 | sabeti

Hello Everybody, I have a problem with a DEK 265Lt, during downloading the vision, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE I have found that this might be due to a broke

Excess solder during manual solder jumper

Electronics Forum | Thu Nov 14 10:18:31 EST 2019 | slthomas

It doesn't look to me like the jumper wire is wetting at all. I would immediately question the solderability - do you know how that jumper wire is finished (plating type)? Also, how experienced are the solderers? It could be that the wire never get

Dek265 GSX Vision hardware error

Electronics Forum | Sat Nov 23 06:05:31 EST 2019 | hemantpang23

Hello Everybody, I have a problem with a DEK 265GSX, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE I have found that this might be due to a broken wire and I have checked all

Internal Oven Calibration

Electronics Forum | Sat Feb 11 18:33:36 EST 2006 | KEN

One factor everyone overlooks is that furnace and external T/C wires are (generally) not calibrated. Unless you are sending your wires to a lab for NIST characterization your T/C wires are NOT calibrated. They (new wires)operate within a specifie


wire searches for Companies, Equipment, Machines, Suppliers & Information