Electronics Forum | Wed Dec 05 09:12:26 EST 2012 | sarason
I have worked construction in both domestic and highrise in the last few years. Not wearing safety gear is an immediately sackable offense. It is not a bad way for it to be. Hard hats are always required on multi-story, steel capped boots are always
Electronics Forum | Wed Mar 20 12:59:10 EDT 2013 | kmots15
We had this issue with a few parts on our universal 8mm feeders. The set up was correct all mechanisms were working, even tried a new feeder. The spring in between the take up wheel and pick point just wasnt cutting it since the adheasion was too m
Electronics Forum | Fri Jun 07 10:02:01 EDT 2013 | sarason
In thirty years of Electronic service I have never had problems with moisture in boards when hand soldered. I have worked on boards in boxes for defense through industrial control, joy rides etc. Sometimes they some back buried in half an inch of dus
Electronics Forum | Wed Aug 14 10:44:04 EDT 2013 | sarason
In my limited experience. A Domestic Dishwasher with no water recycling like which is offered on some of the newer high priced models works a treat. Clearly this is batch. Inline filtering of the water supply is a good ideal. There are several ways o
Electronics Forum | Mon Aug 05 08:48:10 EDT 2013 | simplycomplex85
Our model of machine does not do "blob analysis" so I'm not sure what you mean by that. "Pattern matching" will only pass if I set the pass percentage down to about 45% and I don't feel comfortable with that. When using a solder inspection everything
Electronics Forum | Thu Aug 22 13:31:23 EDT 2013 | bvdb
Re-doing this thread as original seems to have been shortened. Our beloved 24 year old Fuji IP-1 fine placement machine won't start. Has been working fine for the past 6 years but now when the Power button is pressed the power comes on but the FAIL
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Fri Sep 13 08:17:13 EDT 2013 | gregp
Hello Action_101, We are pretty much on the same wavelength as far as moving the cut and clinch and leaving the board stationary. It is the first I have heard about the cut and clinch being difficult to work on but you worked on them so your opinio
Electronics Forum | Fri Apr 11 03:25:57 EDT 2014 | JB
Hello Len. Thanks for the update, I wouldn't say we are getting the hang of it but we are progressing, I now have a vision programming guide which isn't much help when parts are failing, it just states the obvious, set up sizes etc. The light that y
Electronics Forum | Fri Sep 26 19:40:25 EDT 2014 | jfduque
Hello everyone. First, I would like to apologize for my bad English, this is my first post and I came to this forum looking for help. I'm working in a small electronics company, and last year we've decided to invest in our first SMT production li
