Electronics Forum | Mon Aug 06 09:55:32 EDT 2012 | dyoungquist
Techspray makes a liquid called "Eco-Stencil SMT Stencil Cleaner" and also pre-saturated wipes by the same name. We spray the cleaner on the stencil and then use the wipes to clean the paste off of the stencil. Putting 1 wipe in each hand and rub
Electronics Forum | Fri Aug 17 09:32:36 EDT 2012 | jeremymek
I would advise against using IPA for stencil cleaning It may initially seem to produce good results but the way it works you end up with more problems. IPA is good at removing liquid fluxes but it dries out and cements solid fluxes to the stencils
Electronics Forum | Tue Aug 07 09:44:44 EDT 2012 | parmar01
Hi All Im new to the forums, And this my first thread. im the production manager at Broyce Control Everything ive learnt about wave soldering is by trail and error i know its not the best way but it has worked for me. The problem i have been
Electronics Forum | Tue Aug 14 08:06:38 EDT 2012 | milan89
Hello, I am having a problem with Universal GSM1 with the Adhesive head. It's a model with piston pump. When i try to dispens a sping that needs to push the adhesive in the syringe doesn't have power to push it. Everything is well cleaned. Maybe it'
Electronics Forum | Thu Aug 23 21:36:21 EDT 2012 | padawanlinuxero
Hello I would go for a Teradyne Z18xx those are kinda low budget, there are some companies that sell them refurbish right off my head I can think of Rocky Mountain Test Equipment talk to John Cowling (303 693 3322) and for the ICT fixtures so that
Electronics Forum | Tue Sep 18 05:22:34 EDT 2012 | sarason
Try this page for the updated machine An FP-100 about 85 psi. for this model. The basic machines are near identical , just newer plastic moldings. I think I ran mine off a car inner tube and a 12V tyre pump, originally. So that would have been a
Electronics Forum | Fri Sep 21 11:55:31 EDT 2012 | cyber_wolf
Do you have the feeder calibration jigs ? If so it should be pretty self explanatory. I'm pretty sure a CP7 has the same loader system as a CP643. If so, the sensor system can be hairy if you don't know what you are looking at. If it has been crashed
Electronics Forum | Thu Oct 25 13:33:18 EDT 2012 | cyber_wolf
Ken, The photo looks like results I have seen because the gold flash was too thick on the board. This causes a condition known as gold imbrittlement. You may want to get an analysis of the plating thickness. I'm not real experienced with immersion si
Electronics Forum | Wed Sep 26 11:42:19 EDT 2012 | comatose
I have an ap-25 and wish i had gotten the UP-2000 instead. How's that for an answer? The main difference is that the ap-25 uses linear motors and air bearings, whereas the up-2000 uses ball screws. The linear motors are faster, but the whole thing i
Electronics Forum | Tue Oct 02 13:55:12 EDT 2012 | ericrr
OK I can take a hint when asked for a photo. I did not try to take a photo as I thought the close up image would put the picture out of focus, so this is where a bit of graphics works might help explain the problem. When I had a look at the 1206 p