Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb
Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the
Electronics Forum | Mon Jan 22 05:37:35 EST 2007 | dave
Hi All, One of the switches tripped causing no power to the Bottom Cell Inverter . This was reset and Inverter seems to be working fine but the Bottom Blowers are not working which is causing cold joints etc. I am waiting on Electrical Schematics f
Electronics Forum | Mon Feb 12 01:19:27 EST 2007 | Wayne
the center part of the BGA balls may not fully reflow or melt and cause BGA tilt, not functioning working (only press then work) and etc..... the simple way to solve this issue is to use low temperature solder paste, it can melt in between 220 to 225
Electronics Forum | Wed Feb 14 14:11:17 EST 2007 | greg york
We have profiled hundreds of ovens here and it really is dependent on work going through, I walked in on one trial and was faced with an oven that was literally two foot long and told the guy it would not be suited only to profile and run lead free t
Electronics Forum | Fri Feb 23 08:51:38 EST 2007 | dekhead
Are you saying that it works in "no fmi" mode, but not in manual? Please tell me how it works in both. I'm asking you to change things to ascertain the problem, not as possible solution... if you can't get the board to stop in the correct position,
Electronics Forum | Tue Apr 03 20:55:36 EDT 2007 | rob_thomas
Manuel, Try http://www.bartector.com/. I consult at a company in my hometown and they have this in place and works very well with their old and new Fuji equipment. I doubt that it costs 100K. I have no ideea how much it is but I think is worth che
Electronics Forum | Tue Jun 19 10:14:10 EDT 2007 | realchunks
A faster printer..... at less than 14 seconds? I don't think you'll find one. Easier and cheaper to multi-up the board. Another idea is to print a head of time and use magazines to store boards. Most adhesives have huge board life times. An in
Electronics Forum | Tue Jun 19 13:57:40 EDT 2007 | realchunks
Hi Bill, You should contact your local water work dept. and work with them. Every county is different. Sometimes it not what you put in the drain, but how much. They may want to monitor your drain, which is standard stuff. Be prepared to show th
Electronics Forum | Sat Jun 23 11:41:34 EDT 2007 | grantp
Hi, We use 1:1 for 1 mm BGA and it works fine. We used it at 4 thou laser cut stencils when we had a manual stencil printer, but have moved to 5 thou with the DEK and it works ok. We originally went to 4 thou because of paste release, but the DEK
Electronics Forum | Wed Sep 05 10:36:47 EDT 2007 | dwanzek
Hope you found an adhesive that works for you Dback. Thought I felt sharp pain in my back for awhile as did not follow up on this string. Then again, a response may prolong the pain, oh well figured a need for accurate information. FYI for RealHuss