Electronics Forum | Thu Sep 09 14:32:00 EDT 2021 | kumarb
I would switch PCB shops. Unless your oven profile is out of spec, consider a different PCB supplier. We have sourced very high volumes of PCBs (4L-6L) from offshore and can recommend a list of quality shops. Shops that we can recommend are: Sunta
Electronics Forum | Tue Sep 28 19:22:48 EDT 2021 | kumarb
Hi. Aside from the good advice above, wish to throw in our experience with our 1809EXL. Had < 200 on-hours and the oven would not melt the assorted fresh paste we sourced from different suppliers. The s/w reported that the set temps were being
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the
Electronics Forum | Thu Jul 21 05:04:42 EDT 2022 | kamedatec
I live in China and I need to buy a new SMD assembly line. I have 2 NEODEN7 machines that I've used in the last few years to assemble prototypes, they work fine only for prototypes. During that time I created a very practical way to transform Altium
Electronics Forum | Fri Jul 29 11:31:44 EDT 2022 | jojoled
Hi Guys, I have Juki PnP machine with 2 heads, and for some reason, whatever I do, I can not make the machine to use 2independent feeders for parallel picking up single component reference by both heads from 2 feeders. Example , imagine you have a
Electronics Forum | Wed Aug 03 16:02:42 EDT 2022 | spoiltforchoice
This repeats a very similar thread recently. The obvious answers are given already. However there are extra/different steps that can be taken depending on where your data has come from. If you are an OEM and you are building using data that was gener
Electronics Forum | Sat Jul 03 01:09:29 EDT 1999 | DEAN
| | I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/chan
Electronics Forum | Wed Jun 30 10:00:33 EDT 1999 | Mcox
| | | | | | | | snip | | | | | | | | | John and Dave, | | | | | | | | | | Again, I don't work with larger chip devices with this issue. The company I now work with developed a strategy, based on considerable research (as others of us did in the pa
Electronics Forum | Wed Jun 30 11:07:16 EDT 1999 | Earl Moon
| | | | | | | | | | snip | | | | | | | | | | | John and Dave, | | | | | | | | | | | | Again, I don't work with larger chip devices with this issue. The company I now work with developed a strategy, based on considerable research (as others of us d
Electronics Forum | Wed Jun 02 15:11:56 EDT 1999 | MD Cox
| | ok, ok, so I'm not an engineer. I'm a salesguy ( and that's nothing to be ashamed of...) Here's my dilemma. I represent a contract manufacturer who is in the early stages of quoting on "turnkey" assembling of a circuit board for a manufacture