Electronics Forum | Mon Jul 15 00:21:46 EDT 2002 | tjyard
Frustrated? Where do I start. Our company just lost a contract assembly job we have been providing to Altera Corp for five years. They sent it overseas to China. We had to lay everyone off at our assembly facility. Yeah, you better learn to spea
Electronics Forum | Mon Jul 22 13:16:35 EDT 2002 | Claude_Couture
We are drifting deeper into market philosophy... Yes, capitalism is the motor to a healty market economy. "Running to catch up on the latest gadgets even if my 10 year old cell phone is still working fine and fills all my needs" cannot be sustained.
Electronics Forum | Thu Jul 18 09:55:05 EDT 2002 | gdstanton
Mike, When we measure solder inspection yield by dividing the number of defective joints on a CCA by the total number of joints on the PWB. A defective joint is classified only once. That is we don't count multiple defects on the same joint. Our
Electronics Forum | Thu Jul 18 11:31:03 EDT 2002 | Mark S.
>But since we are a low volume high mix operation I need to account for almost every part used. I'm in the same boat, and we do more changing of feeders than actual placements it seems. What I have done which has improved things a lot is in our MRP
Electronics Forum | Thu Jul 25 03:01:25 EDT 2002 | martz
We experience e-test failure due to BGA problem. The product was subjected to 40 deg.C hot air blowing on the BGA area and it works pretty well. The product then failed when the temperature became 36 deg. C as the hot air blower is withdrawn. If it
Electronics Forum | Tue Aug 13 20:57:01 EDT 2002 | davef
We don�t use this glue. What does Heraeus say about your condensate? [I'm With the previous poster. Your condensate sounds like goop from NC flux not glue.] How to clean out a 3 meter length of chimney? Depends on your tolerance for pain * Take
Electronics Forum | Wed Aug 14 21:13:30 EDT 2002 | davef
Insulating tab approach, like: * Go to page 5 of http://www.kalatel.com/lit-rack/install-man/kts_253_253-16_man.pdf * http://support.tandy.com/support_radios/doc64/64039.htm * Go to �Fixing�, Step 6 of http://www.sunvic.co.uk/TLX%20Digital%20Room%2
Electronics Forum | Wed Aug 21 18:13:21 EDT 2002 | johnlee
Kevin, There are a number of custom integrated systems that perform automated insertion of "odd" components. These system use either a robot or cantilevered X,Y,Z Cartesian motion systems. Our systems have accepted standard and custom component feede
Electronics Forum | Tue Aug 27 11:08:24 EDT 2002 | slthomas
We use an evaporator, so that we only have a sludge of flux residue and solder metal to dispose of via the hazmat handling service. We also route stencil washer waste water into it. We use a 30 gallon drum and have it hauled off maybe twice a year,
Electronics Forum | Tue Sep 10 23:37:22 EDT 2002 | Steve E
Dear Sir I can assure you that I have personal experience with the part in question.This part will run with the recommend vision types ( 11 & 12 ). I noticed You neglected to state how old the machine was, and the amount of hours. The CP-6 series hav