Electronics Forum | Thu Apr 17 17:57:13 EDT 2014 | proy
Hello We use a 5 zone conceptronics HVN70 and never before have we had something we could not do including 6 layers Rohs complicated boards. Recently we had a larger - simple 2 layer board - all 1206's etc however there are 15 pcs of a LARGE high m
Electronics Forum | Wed Apr 23 09:38:05 EDT 2014 | rgduval
Get in touch with your paste manufacturer. They should have a data base of different oven types/zones, and can give you "baseline" settings for a medium thermal density board that has been proven to work well with their paste. After that, it sounds
Electronics Forum | Sat May 17 10:38:49 EDT 2014 | sarason
I hate to say this but in all probability this wont work. I have built real strain gages and they depend on the change(Co-effiecent) of resistence with strain(or Stretch). since you are connecting you elements up with copper wire it will frm part of
Electronics Forum | Thu Jul 10 13:24:59 EDT 2014 | sargeredarmy01
Ok so here is where I am with everything. I pulled the cylinder and cleaned it out. Didn't find anything out of the ordinary inside. I set everything back up and tested it. Still nothing. I went into the I/O map and tracked down that input, I then
Electronics Forum | Wed Jun 18 18:58:10 EDT 2014 | ke6zoy
Hi All, We leadform components for our assemblies in house and have been tinning the leads using a dip methood by hand into a solder pot. by just handling the components during the tinning and cleaning process we are at times damaging the parts/lea
Electronics Forum | Fri Jul 18 16:57:54 EDT 2014 | guts1872
In the middle of my run yesterday the camera LED's in front and back wont turn on during inspection step. I can manually turn them on in the program edit screen, but as soon as I try to inspect a part they turn off. Was hoping a restart this morning
Electronics Forum | Thu Jul 31 14:52:38 EDT 2014 | rgduval
As I understand it, customized equipment for breaking the headers out can get fairly expensive. I've used two methods to do these, other than using cutters. First, we bought a bandsaw to use for cutting. The only disadvantage to using the bandsaw
Electronics Forum | Tue Aug 05 05:27:53 EDT 2014 | philc
Another interesting response! The PMTech machine looks interesting, but I doubt we will get clearance to spend this amount for a machine that doesn't get used several times daily. I wonder how much the Blundell machine is? Anyone have a costing for
Electronics Forum | Sun Aug 17 19:06:42 EDT 2014 | natashakt
Hi All, I have been looking in to some failures of PCB's in Assembly. After SMT the boards are stored for different periods of time in high humity environment (72% RH and 21.4 degrees Celsius) before being sent to Assembly to be handsoldered/put thr
Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search