Electronics Forum | Mon Jul 01 14:46:47 EDT 2019 | assuredtech
It's been awhile but yes, if you do not allow the machine to optimize your program and your placing sequence is such that the tallest component is perhaps the 1st or last placement so it doesn't bump into other components, next is you may look into a
Electronics Forum | Mon Jul 08 12:21:17 EDT 2019 | slthomas
I forget which type of CTA that machine has so I probably won't be much help. It's been ages since I worked on them but it doesn't look like you'll find many people that have. That said, usually if you get things aligned properly and it still bends
Electronics Forum | Tue Jan 05 14:45:27 EST 2021 | aharper
We had to register our machine with ASYS Group to get the digital manual and to receive tech support. Unfortunately, I am not at liberty to distribute the manual outside our company. As far as the rear computer, I can't imagine your machine working w
Electronics Forum | Fri Jul 26 06:16:02 EDT 2019 | spoiltforchoice
We have enough volume/oversized products that batch vapor doesn't quite work. Once you move into the quasi inline or fully inline vapor system they become eye-wateringly expensive. Plus you get an entirely new process to learn, potentially increased
Electronics Forum | Fri Jul 26 09:34:10 EDT 2019 | spoiltforchoice
I've mostly been looking at the smallest oven in the range of the bigger ovens as it were. So that's the 1707 from Heller and similar sized units from elsewhere. However apparently Heller are apparently bring back the 1500 series in the form of a 150
Electronics Forum | Fri Jul 26 14:19:14 EDT 2019 | slthomas
Since our process engineer took off for allegedly greener pastures I've taken it upon myself to provide whatever assistance I can with the process side. In this case I'm trying to get the "2 1/2D" inspection up and running. They've never us
Electronics Forum | Mon Mar 23 15:08:21 EDT 2020 | slthomas
Unfortunately I didn't do the work...I just requested it from maintenance. I think the E5's were really a completely different beast than an E4, but I've never used an E4 so really don't have any experience. I purchased 3 E5's when new for a previou
Electronics Forum | Fri Aug 02 12:57:38 EDT 2019 | aaronhodge
Hello All, I am a few months in with a new employer, spending much of my time with AS9102B First Article Inspections. This company is a Micro-Chip and PCA OEM but also designs, develops and manufactures products for a handful of customers, as well.
Electronics Forum | Tue Aug 06 16:49:57 EDT 2019 | jmedernach
HI, The short answer is, "whichever machine finds your defects." I would suggest evaluating machines based on a common vehicle. Make a bad board and identify the defects. Make a good board and have your vendor teach and tune the machine to the goo
Electronics Forum | Wed Aug 07 14:51:31 EDT 2019 | alexeyzb
Hello! I used three SpeedPrint 210avi in our factory. They worked ok, but i had some problems: 1) Printer foil clamps. Steel thin blade which press PCB on table is connected to metal base by glue. As a result you need to change it every month, but af