Electronics Forum | Tue Aug 03 18:11:21 EDT 2004 | davef
Improper washing of water soluable flux residues can be a major contributor to flux residues remaining on the board surface. ;-O That you appear to be only complaining about the pathetic state of the ability of your washer to clean under BGA, it may
Electronics Forum | Wed Aug 18 00:53:16 EDT 2004 | Grant
Hi, I think you cannot go wrong with Convection. If you want to experiment with VP, just get some of the fluid and put it into a pasta cooker on a standard domestic hot plate. Have a basin full of cold water so after reflow you can lift the cooker a
Electronics Forum | Thu Aug 26 00:27:45 EDT 2004 | valuems
There is so much confusion about this cognex not reconized statement, and it's time to step in. The box on the out side is a cognex 2000 system. The reason for the cognex not reconized statement is very simple. MPM wrote the 4.1y software looking
Electronics Forum | Sun Aug 29 19:17:34 EDT 2004 | aqueous
Chen, It is always best to place one�s effort on determining the cause and content of the residue rather than trying to work around it. The first thing you must determine is the nature of the residue. Is it flux? In many instances, the residue is
Electronics Forum | Tue Aug 31 22:03:30 EDT 2004 | KEN
If you have control over your design (as in an OEM) ENTEK can be a managable alternative. IF your like me (a CM), you get one of everything ever imagined. There has been much ado with ENTEK. Not every product is apropriate. For instance I have cu
Electronics Forum | Thu Sep 02 10:24:35 EDT 2004 | dj_jago
Greetings from the UK: I have been quite fortunate to lead (no pun intended) our company towards lead free sooner rater than later. One of our customers produces a product which is refurbushed every 6 months or so and sent back into the market. A
Electronics Forum | Tue Oct 12 11:32:22 EDT 2004 | fastek
Stefen- When looking at it from your perspective only it makes no sense to off-shore. The machines and operators are but a small part that goes into the decision to move overseas. The bigger picture is the fact the "entire" operation gets outsourced.
Electronics Forum | Tue Oct 19 22:51:07 EDT 2004 | KEN
I feel it is less pressure from consumers and more from stock holder increased demands for dividends. Every quaters end our publicly traded customers go bezerk on increased orders to show increased finished goods and less component inventory. All t
Electronics Forum | Fri Oct 15 03:00:21 EDT 2004 | pierrenoir
Hello to you all I was hoping one of you guys would be good enough to give me some advice on a problem I am having with some training simulators I have developed for my work. I have basically built two electronic control simulators to duplicate the o
Electronics Forum | Tue Oct 26 13:40:47 EDT 2004 | Paul_pmd
Have the SOIC tested by independant. Clarify as to weather or not you have run this board before. Check to see if the board has been rev'ed. Sometimes IC's are rated at a clock speed or by axcess time. Engneering on this board may be at the tolorance