Electronics Forum | Wed Jan 26 06:40:17 EST 2005 | mattkehoe
You can place them by hand and reflow them using a toaster oven if you use SIPAD ssd with adhesive flux. Yes, I said a toaster oven. It is being done!! Convection ovens work best. Give me a call and I will send you some sample boards to try it out
Electronics Forum | Wed Jan 26 08:36:06 EST 2005 | jdengler
Sasha, A standard RS-232 cable with the proper connectors would work. If you want you can make it. Normally the PC will have a DB-9 theses days so the wiring would be PC Machine DB-9 DB-25 2------2 3------3 5------7 Good
Electronics Forum | Fri Jan 28 15:09:56 EST 2005 | cardinal
Hi Glenda, I have 5 wavesoldering machines in stock. Electra, two Vectra's and Ultra Pak and a Sensby. I would be happy to work with you on your lead free application. We offer refurbished machines as well as lead free conversions for used wavesol
Electronics Forum | Mon Jan 31 15:34:13 EST 2005 | Brad
Hello, We just cleaned our wash a few months ago. I used white vinegar. No dillution, straight up in a spray bottle. Spray it on let it sit for a few minutes, comes right off. You might need to use a stainless scrubby on some of the tough areas, But
Electronics Forum | Thu Jul 07 17:59:58 EDT 2005 | russ
I have found that if you place it "upside down" with the paper on the bottom they work very well also. The paper has a tendency to warp during heating which causes the no connects. by adding flux to the preform you are essentially sticking the pref
Electronics Forum | Mon Feb 07 14:54:30 EST 2005 | davef
Industry assembly procedures say: * ANSI/IPC-A-610, in section 3.4.1, as a guideline, indicates that "There must not be any eating, drinking, or use of tobacco products in the work area." * ANSI/J-STD-001, in section 3.7, "Eating, drinking, and/or u
Electronics Forum | Mon Feb 07 15:41:34 EST 2005 | etienne
I our shopfloor, we are allowed to drink water. I think that if it is prohibited to drink water in Production, then there must be like short breaks so that one can go and drink water from the canteen. It is always a headache when it comes to decide s
Electronics Forum | Thu Feb 10 09:01:40 EST 2005 | russ
I have done that also, It does work well. One issue we had was that the mask didn't come right off during the first wash cycle since it was put on much heavier than the mfgr suggested (.01"). We had to soak them in some water first to soften it up
Electronics Forum | Wed Feb 16 14:47:04 EST 2005 | Valerie
Mike, To answer your question, Yes we have thru-hole parts on the boards that we converted to double-sided reflow, we use pallets to select solder the leads. I suppose Masking would work, but that's using a lot of mask. Can I ask, whats preventing
Electronics Forum | Wed Feb 16 16:41:31 EST 2005 | Mrduckmann2000
Pallets will not work in this case because the wonderful designers put 0402's between the legs and all around the legs of the thru-hole connectors. There are 18 thru-hole connectors on this board and 200 - 0402's around them. The 0603's that are al