Electronics Forum | Mon Mar 06 21:58:56 EST 2006 | kent_peterson
Good machine! Just like most part libarys don't let the operators change part profiles. Haven't seen it place 0201's but 0402's have no problem. Tape splicing for the feeders is a problem. The eject wheel gets jammed with anything other than splice t
Electronics Forum | Tue Mar 07 08:44:10 EST 2006 | billyd
Craig - You should not use the leaded parts, as you are, in all likelyhood, going to see massive voiding. We just went through this same deal where I work, because a manufacturer sent us the incorrect parts. You can go with lead free parts with regul
Electronics Forum | Wed Mar 08 10:46:10 EST 2006 | Chunks
Don't forget to buy the "Lead free heelstraps, smocks, wriststraps, hairnets and repair table" too. They cost twice as much, but you have to have them! We use regular wick and it works well with the LF solder. Vendor even ageed there was no need t
Electronics Forum | Wed Mar 08 10:46:40 EST 2006 | Chunks
Don't forget to buy the "Lead free heelstraps, smocks, wriststraps, hairnets and repair table" too. They cost twice as much, but you have to have them! We use regular wick and it works well with the LF solder. Vendor even ageed there was no need t
Electronics Forum | Thu Mar 16 14:15:54 EST 2006 | ratsalad
Well I honestly can't say that I have enough flow, so that's a good point. We don't have a flow meter or manometer on our reflow exhaust. How do you measure that? Or, is it just that you make sure your exhaust path is clean and the blower is wor
Electronics Forum | Wed Mar 15 11:29:38 EST 2006 | cjd
Anybody ever use SAM to inspect a bare pcb? What can you see? Is the scatter noise so bad you can't even see the copper layers? I would think you could at least see to some depth and then flip the board over. I work in a R&D environment so speed
Electronics Forum | Tue Apr 04 09:39:14 EDT 2006 | pjc
No, Orbotech is pretty popular wordwide I'd say. This is suppose to be a technical forum, not an "opinion" forum. Just becuse an AOI machine works well in one appliaction does not mean in all. Plus, after sale support varies regionally. You should do
Electronics Forum | Fri Mar 17 12:02:23 EST 2006 | derengmao
I have a QSA30V, but the up-look vision camara could not identify parts, although calibration PASS and parts show on the screen are OK. I have never see a working up-look camera for QSA30V. Could you help me to to fix, or is it workable?
Electronics Forum | Tue Mar 21 21:24:48 EST 2006 | alphaman
I recently acquired an older Dover Soltec 6522/23cc wave solder machine. The machine appears to be in good working order and I thought I would get it running to use as a backup. Can anyone tell me where I might get an operators manual. I have the
Electronics Forum | Wed Mar 22 03:00:09 EST 2006 | meritajs
Hi All, We have problem with Zevatech FS-730 This machine shows error E202062: "System error: T axis of head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low speed it works s