Electronics Forum | Sun Nov 04 01:20:38 EST 2018 | alexeis
Hi Rob, We have a solution, called DCollector, that works with serial numbers and route card. Also, if you have a fail, you must write it and serial can't continue in the route until you fixed it and report pass. If you want more information, plea
Electronics Forum | Fri Jan 04 05:50:37 EST 2019 | bane016
It's nice to see that you've solved the problem...panasonic npm w2 is very powerfull machine but asks everything to be perfect and everything is pure to work well...looking for a clean ventilated room without dust..regular maintenance daily, weekly,
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Wed Dec 19 16:05:10 EST 2018 | ldavis
I created a spray fluxer for our wave solder years ago that is still working well although does consume a lot of flux and is also rather messy. It's cheap and easy though so what the heck, right? I just machined a manifold that will hold four BETE
Electronics Forum | Wed Jan 02 12:03:13 EST 2019 | jdengler
They go through TN-3 to get to the TSA-200A D/A module. This is all in the MTU. It's been a long time since I worked on an IP-2 but see if you can get to the I/O screen for the MTU. Have someone flag the in range sensor and see if the input status on
Electronics Forum | Wed Jan 23 20:01:20 EST 2019 | padawanlinuxero
Hello Sounds to me that the problem might be with vaccum and lot of it, after the component is place theres a small amount of air that pushes the component away from the nozzle in MYDATA we call it a kiss in my facility, have you check that the air
Electronics Forum | Wed Jan 30 00:56:00 EST 2019 | kiransahu
Sounds to me that the issue may be with vacuum and part of it, after the segment is put there's a little measure of air that pushes the segment far from the spout in MYDATA we consider it a kiss in my office, have you watch that the air that "puffs"
Electronics Forum | Tue Feb 05 23:51:24 EST 2019 | ushir
Hi all, I am looking for recommendations please on SPC software for an EMS. We currently have an in house system for doing this but it has not worked too well and and would rather go with an off the shelf tool instead of recreating the wheel. We es
Electronics Forum | Wed Feb 13 09:15:43 EST 2019 | SMTA-Bob
With any board assembly or unit that has a high mass its also possible to just place it in an oven to raise the core temperature of the mass that is holding back the rework This works for any difficult to rework product. It would be useful to have a
Electronics Forum | Thu Apr 25 05:26:46 EDT 2019 | pdrirrework
Joe, If you havent already, please take a look at our Focused IR Rework Stations. I am confident we have a machine which will be perfect for this aplication, you will also get the benefit of a visible heating area, there is no more Nozzles/Guess wor