Electronics Forum | Wed Aug 03 11:08:24 EDT 2005 | PWH
We use the following stuff from "Biral USA": BIO30 Synthetic High Temp Oil � Chain Oilers NMG-400G � No melt grease - miter gears/lead screws AS500ML � Anti-size spray - lead screws, drive sprockets, rail support L-brackets It seems to work good
Electronics Forum | Mon Aug 08 22:32:18 EDT 2005 | adlsmt
If you are using fine lines and tight spacing ENIG may be cheaper than HASL. This is because there is not as much bridging at the board house between traces so they do less touch up. This would probably be even more true with no-lead. We have been us
Electronics Forum | Sat Aug 06 11:47:24 EDT 2005 | jax
I have not used the machine so I cannot talk about ease of programming, actual cph, etc... but: There are a few things that interest me. intellegent feeder positioning - doesn't seem to matter where you put them, even while the machine is runnin
Electronics Forum | Tue Aug 09 17:01:59 EDT 2005 | dougt
Is there a need for a professional conveyor swapper? Could I start my own business and make enough money doing something like this? I haven't worked on this conveyor but I'm sure I could figure it out. As it was said previous it's probably only a c
Electronics Forum | Tue Aug 09 06:21:19 EDT 2005 | bwet
Ladies and Gents: There have been several ways discussed in the trade press and in papers re: how to seperate/keep seperate Sn63 and l-f hand soldering tools. Some claim comepletel seperate hand soldering tools are required, while others claim that
Electronics Forum | Thu Aug 11 08:56:20 EDT 2005 | pjc
Some causes of lack of top side fillets (hole fill) are: 1. Not enough pre-heat (a top side preheat will help, if no-clean flux, be sure to follow flux mfrs specification for top side board temp just before hitting wave) 2. Not enough flux 3. Flux i
Electronics Forum | Thu Aug 11 13:09:11 EDT 2005 | bman
In addition to Pete's fine tips, here's one we have successfully used in similar situations as long as you're using OA flux. Get some kind of pump action spray bottle (like hair spray comes in) and fill is with some of your wave flux. Use the bottl
Electronics Forum | Thu Aug 11 16:25:27 EDT 2005 | pjc
Just be careful on preheat. They tend to be weak on those small low cost machines. How well they work for you depends on what type of boards you plan to run. Large thick boards or high thermal mass boards will not likley run too well. Take boards to
Electronics Forum | Fri Aug 12 20:09:41 EDT 2005 | dorklover664
First off I would like to say it's good to be back. I haven't been working production and I'm really glad to be back. Next... I am looking for either a used MyData flex or 12/16 magazine. Cheap is the key (new company has less then 50 employees)! We
Electronics Forum | Wed Aug 17 10:46:48 EDT 2005 | pjc
MPM did not discontinue the camera, the camera manufacturer did. It�s not a custom made camera for MPM. Try searching used or second-source cameras. There are three types of vision systems offered on the SPM: manual cross-hair, semi-auto and high-res
