Electronics Forum | Fri Jan 30 09:29:22 EST 2004 | caldon
Joe- You confused me In the subject it has SMT and in a posting you say Through hole components. I was incharge of getting equipment for a research and teaching facility called ACI (Some know it as the EMPF). I was tasked with getting equipment at n
Electronics Forum | Fri Dec 10 11:38:39 EST 2004 | Terry R.
Has anyone out there actually upgraded from Fujicam to Assembly Expert? I would like to know what you thought of the upgrade procedures/costs, and what you think of the AE software. We have started using Flexa on our lines and are currently program
Electronics Forum | Sat Feb 07 18:02:20 EST 2004 | Mike Konrad
Hi Steve, The Windows 98 version of the SMT800-LD software provides for two levels of password protection. One for general use (creating, editing, deleting programs), and the other for maintenance functions (individual device control, machine confi
Electronics Forum | Sat Feb 07 22:03:25 EST 2004 | Dean
I have run into this before with a P&P machins. In one instance the 4 levels of passwords were published in the first revision manuals. OK, guess tech editors missed that??? FYI Anyways, I just wanted to mention that changing or altering software
Electronics Forum | Tue Feb 17 10:08:17 EST 2004 | russ
Do you have a bake oven that will reach 200C? You could bring a batch of boards up to temp and then start the pluckin'. A sfar as the solder goes if you apply flux to the leads they remove very clean as far as solder goes. To remove the flux we pl
Electronics Forum | Tue Feb 17 10:55:49 EST 2004 | bobbyv40
Hi Dave, 1. As far as speed of removing componants, we use a board preheater to bring board temp to about 150 C. Then add a flux and then flood all 4 sides of the componant with the low temp solder. Using a suction tool the part comes right off. The
Electronics Forum | Tue Feb 17 17:55:38 EST 2004 | bman
I might be saying something that will get me laughed off of SMTnet forever, but when faced with a similar problem here's what I did. Since I was removing parts I didn't see why I would be concerned about all the things that go on in a good temperatu
Electronics Forum | Tue Mar 02 17:26:24 EST 2004 | pjc
I worked on MicroFlex. All axis move via electric motor drive. Carraige reapatability is +/- 0.0005" (12 micron). Cameras position more easily on linear bearings than the swivel type. The alignment accuracy and repeatability easily supports sub-20mil
Electronics Forum | Sat Mar 20 08:37:06 EST 2004 | Primus
The BioAct SC-10 wipes work great, but I've noticed some contamination in our solder joints after I began using them on the stencils. After cleaning the paste off the stencil with the wipes, I started spraying the stencil down with isoproponal and bl
Electronics Forum | Mon Mar 08 04:52:25 EST 2004 | martin
Hello i have some problem with our dynapert. Wonder if you could give me some advise. The problem is our machine worked not so well so we started to take out one by one of the cards and check all ic's so they was properly inserted. But when we ca