Electronics Forum | Thu Jul 08 13:21:18 EDT 1999 | Bob Barr
Ron, We use 100 pin straddle mount connectors on some of our 1.6mm boards (up to eight per board.) They come to us from the vendor with a bead of solder on the somewhat 'J' shaped leads. Our process is as follows: Mount connector to board with hard
Electronics Forum | Wed Jul 07 13:28:30 EDT 1999 | Wolfgang Busko
| We are looking for some subcontractors to do surface mount | technology boards for us. Is there anything I should pay specific | attention when I visit the subcontractor's site? | Thank you for any advice | Hey, there�s already a lot of advic
Electronics Forum | Wed Jul 07 22:27:57 EDT 1999 | Dave F
| | We are looking for some subcontractors to do surface mount | | technology boards for us. Is there anything I should pay specific | | attention when I visit the subcontractor's site? | | Thank you for any advice | | | Hey, there�s already a
Electronics Forum | Tue Jul 06 10:12:44 EDT 1999 | John Thorup
| | Is the no clean solder paste as good? We are wondering if we can elliminate the wash when we change from through hole to surface mount. | | | John, | | No clean is as good as your process, and the paste you are using. Everything I do is no cle
Electronics Forum | Mon Jul 05 02:32:14 EDT 1999 | Vinesh Gandhi
Dear All, We are a medium sized Electronic manufacturing company manufacturing computer motherboards and Telecommunication products. We have a big debate going on within our company regarding the defect rate measurement technique. At present we
Electronics Forum | Fri Jul 02 14:32:44 EDT 1999 | Dave F
| I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/change
Electronics Forum | Fri Jul 02 14:50:39 EDT 1999 | Earl Moon
| | I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/chan
Electronics Forum | Fri Jul 02 16:16:53 EDT 1999 | Scotty
| | I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/chan
Electronics Forum | Wed Jul 07 08:54:20 EDT 1999 | M Cox
Snip | John, | | You said a bunch. My biggest problem running Fuji, Panasonic, or Sanyo high speed stuff is that they are meant to run free. They are meant, in my mind, to run as thoroughbreds. | | I watch 6" reels placed on feeders, placed on the
Electronics Forum | Thu Jul 01 16:43:52 EDT 1999 | Dave F
| | | Could somebody tell me what means Leaching, ie: "Leaching of terminal end face exposing the ceramic"? | | | | | Roberto: Leaching, according to the SMTnet Library of Terms: | | | | Leaching. Dissolution of a metal coating into liquid solder.
.gif)
