Electronics Forum | Mon Jun 01 20:37:54 EDT 1998 | D.Lange
| | Got handed an assignment for which I'm not totally qualified. Don't expect this forum to had me all the answers. Some answers are obvious as the device types are fairly self explanatory. | | As everyone knows, IBM had problems with their ceramic
Electronics Forum | Fri May 29 20:15:15 EDT 1998 | Steve Gregory
Whoo-doggies Jason, you said a mouthfull!! (GRIN) Anyways, 'member what I said about me being a pack-rat? Guess what? I found some documentation that I've had for a while that does document the self-alignment forces that goes on when reflowing. I ha
Electronics Forum | Wed Jun 10 06:36:09 EDT 1998 | RogerB
Were in similar situation last year and opted for the Mydata. Very satisfied ! | | Our company is currently looking to implement a SMT production line. What I am looking for is feedback on people's experiences with various machines. | | Here's what
Electronics Forum | Fri May 22 10:43:23 EDT 1998 | Mike Konrad
You're right Earl� Drag soldering is a dead issue as far as new technology is concerned. They do, however, work for most through-hole boards� but so do wave machines. There are only two manufacturers left that still produce drag soldering machine
Electronics Forum | Thu Jun 11 07:28:12 EDT 1998 | smd
Before risking screwing up the alignment of the frame, and upon the advice of several SMTNET users, I decided to see if I could get away W. just changing the screws. I found screws with 2x the pull strength as Alpha's. But they didn't fit!! The Alph
Electronics Forum | Tue May 19 21:02:20 EDT 1998 | Steve Gregory
Hey there ya'll... I was reading the messages from Earl asking where he could upload some articles he wrote, and I was asked how one goes about putting a image in the messages here... Ya'll see down at the bottom where it says; "Optional Ima
Electronics Forum | Tue Jun 09 00:53:06 EDT 1998 | Dave M
| | | Last week I posted a message on rotary chip waves that stated that the drive shaft had a protective boot around a u-joint that degraded and exposed the joint. | | | Someone from the manufacturer read it and contacted me. He told me the problem
Electronics Forum | Fri May 15 12:01:34 EDT 1998 | Justin
| | We understand that testing for ionic contamination and surface insulation resistance measure different properties. We assemble printed circuit boards for other companies. We will not get combs on 90% of the boards that we assemble. | | We have
Electronics Forum | Mon May 11 17:35:01 EDT 1998 | Steve Gregory
On 11 May, 1998 Todd wrote: | We are having continuous bridging problems with the trailing | leads on a 26-pin D-sub through-hole connector. The pitch is | 0.100". The connector is going through the wave at approximately | a 20 Degree angle. Does
Electronics Forum | Fri May 08 16:30:59 EDT 1998 | Chrys
| I am running boards with gold fingers on a pallet for | masking purposes. The pallets worked fine for a while | but know the gold fingers are getting solder on them. We | have tried everythin: new pallets, cleaning the pallet | and board to be s
