Electronics Forum | Thu Jun 25 12:05:34 EDT 2020 | spoiltforchoice
There is a fairly recent one. And all the conculsions need things you don't have. Buddy loading - so one person loading one verifying everything. Barcodes - gets rid of people misreading labels mixing up 4k7 with 47K or nbot seeing a decimal point o
Electronics Forum | Tue Jun 30 17:47:57 EDT 2020 | rsatmech
Manual method is always risky. Evening with all sorts of scanning people are loading it wrongly. Below are the recommendations I have. (Kindly comment if anything don't seems to be a solution) 1) peer to peer check - once loaded check the value usin
Electronics Forum | Tue Jun 30 11:39:21 EDT 2020 | stephendo
The best I saw was two people set up and then two other people verify the set up. They still managed to wrong parts on. Day shift loaded the parts but did not have time for the independent check. Afternoon thought that the second check had been done
Electronics Forum | Wed Jun 01 12:06:49 EDT 2022 | proceng1
I am not quite clear what you are asking, but I'll give it a shot. Once the P&P program is put into the machine, the operator will load a bare board and step through the program using the machine camera to verify that part outlines match up to the bo
Electronics Forum | Wed Apr 07 09:43:55 EDT 2004 | Alan
We currently use the bartector system on our CP6. It has saved us quite a few times with wrong part numbers being loaded on the wrong location. (rework for certain parts would have been a nightmare) It is extremely easy to use. I was not involved
Electronics Forum | Mon Mar 13 20:16:39 EST 2000 | Dreamsniper
If an operator loaded a wrong value of component with the same packaging, say 0805, on a feeder slot. how will the program verify this situation? or an operator interchanged 2 0805 capacitors with different values from feeder slot #5 and feeder slot
Electronics Forum | Mon Mar 13 20:16:39 EST 2000 | Dreamsniper
If an operator loaded a wrong value of component with the same packaging, say 0805, on a feeder slot. how will the program verify this situation? or an operator interchanged 2 0805 capacitors with different values from feeder slot #5 and feeder slot
Electronics Forum | Sat Jul 27 17:21:19 EDT 2013 | ericrr
A mistake happened at our company before I got there where a wrong value was used, so now we have to check it with someone else to make sure the old empty reel is the same value as the new full reel. Some months after I started, I decided to check t
Electronics Forum | Wed Apr 21 07:32:04 EDT 2004 | podge
Hi, We have been using the Crest Solutions Reelscan system here for about 3 years on 8 lines and it has pretty much eliminated wrong part placement. We use it on a variety of SMT placement machines and i believe it can be adapted to any type of place
Electronics Forum | Sat Mar 24 12:31:31 EDT 2007 | diesel_1t
Hi there. Ok, i have a little big question for fuji Erudites: when machine run out of parts on any device it tells to machine "parts out (and part number)" So, a signal from anywhere (maybe a PLC output) will tell to the machine "hey i'm out of parts
