Electronics Forum: x-out 10% (Page 1 of 2)

X outs

Electronics Forum | Thu Jul 25 21:41:03 EDT 2002 | davef

1.0 X-OUT POLICY 1.1 Each Panel not to contain in excess of X% X'd-Out boards. 1.2 Each X-Out board to be marked in a manner so that Pick & Place equipment will not attempt to insert those boards X'd-Out such as fiducial reference hole for paneliz

part x-out from board when exit in mirtec offline pc.

Electronics Forum | Fri Dec 27 07:20:38 EST 2019 | dipak123

We have Mirtec MV-6 OMNI machine. If programer changes in part number ,then that part x-out from it's place.Value of X & Y incresed 10X compare to other parts in ATT.

Board House Pcb Question

Electronics Forum | Wed Mar 15 04:32:14 EST 2006 | rlackey

Hi Brad, I don't know if this helps, but we had a policy of not accepting x-outs on rigids, and of max 10% per panel on Flexy boards (as long as the local fiducial was blacked out for the bad board) I'm always suspicious of x-outs as it points to pr

X-Outs and Panel Arrays

Electronics Forum | Wed May 14 11:10:56 EDT 2008 | scottefiske

Anyone out there in SMT land know the premium you will pay by not accepting any X outs?

X-Out Board

Electronics Forum | Thu Feb 16 12:16:36 EST 2012 | jax

I would assume every EMS company runs into this issue on a daily basis. Before we get to how a machine handles it, I would recomend setting up an acceptance criteria with your board supplier... if you plan on accepting them at all. (ex. No more than

Board House Pcb Question

Electronics Forum | Fri Mar 17 14:53:08 EST 2006 | Board House

Hi Brad, Being that I work for a board house here is my take on this issue. In the past it used to be 1 scrap per palt up to 10% of the total order. scrap is supposed to be sepperated to location and packaged sepertaly. Then it turned into No Scra

X-Outs and Panel Arrays

Electronics Forum | Wed May 14 11:29:56 EDT 2008 | dphilbrick

It varys like anything on the shop and the volume. We've seen as little as no charge to 10%

X-Outs and Panel Arrays

Electronics Forum | Wed May 14 15:15:03 EDT 2008 | boardhouse

Hi Scott, I have worked for a State side PCB Manufacture and now a Taiwan Manufacture. At both shops the up charge was based on how many up the pallet array was plus layer count and complexity of product, charges ranged from free to 15%. Standa

Quad 4C reject PCB stickers

Electronics Forum | Wed Jun 19 06:59:43 EDT 2013 | rollon65

Hi Bobpan Thanks for the reply. I taught the reject mark but there appears to be no way to adjust the lighting for this purpose like there is in the fiducial teach screen. I have never accepted PCBs with X-outs before but agreed with my supplier t

Philips Topaz badmark recognition questions

Electronics Forum | Mon Nov 26 10:35:58 EST 2007 | slthomas

We've been using fids as badmarks on panelized boards, with reverse recognition so that an uncovered fiducial is a good mark. It's worked fine with 1.5mm fiducials but now we've run into problems with a board with 1mm fids and we can NOT get it to wo

  1 2 Next

x-out 10% searches for Companies, Equipment, Machines, Suppliers & Information