Electronics Forum | Sun Mar 10 07:43:59 EST 2002 | Tal
how siemens line computer automatic calculate the tolerance for the x,y body and for the Packaging X,Y Tol ( i need a rule or formula)
Electronics Forum | Tue Feb 01 11:34:55 EST 2005 | Dougs
Has anyone heard of any software that can be used to clean up or manipulate x-y placement data. We are a small contract manufacturer with various customers, some who supply good x-y data to component centres and some who supply x-y data to a pin or
Electronics Forum | Fri Feb 01 07:11:07 EST 2019 | bobpan
x and y are the same...just change switches. t and z are the same...just change switches. The voltages on the cards are different(x/y same--t/z same)....i do have a procedure somewhere that allows you to make an x/y card into a t/z card. good luck
Electronics Forum | Wed Jan 20 08:18:20 EST 1999 | Claude Couture
The situation: When I press the "ZERO" button of the dip inserter, the x-y table moves very slowly toward the -x -y corner. If I release the button, the x-y table stops. The 36 vdc is dead. I replaced the "1REC" (it was fried) and the problem is st
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Thu Feb 14 08:13:00 EST 2002 | jax
Dave, WOW :0
Electronics Forum | Wed Jul 06 09:05:27 EDT 2005 | namc
Try scancad -- http://www.scancad.com/
Electronics Forum | Wed Jul 06 09:06:23 EDT 2005 | Jack
Try scancad -- http://www.scancad.com/
Electronics Forum | Fri May 22 17:03:26 EDT 2009 | voytek
Thank you Steve.
Electronics Forum | Wed Aug 18 00:45:08 EDT 2010 | camtech
Why not use some PADs inside the board for X-Y index location?
