230 xy data export results

Electronics Forum: xy data export (Page 1 of 23)

x-y data generation

Electronics Forum | Wed Jul 06 08:32:11 EDT 2005 | aj

Doug, Why not insist on the smae fromat from all customers. They can export center cad-data as easy as any other type. Do you send a DFM to your customers? If you tell them that it will improve your turn around time they will send you what you wan

aoi data

Electronics Forum | Wed Jan 24 21:29:43 EST 2007 | davef

Board fabricators commonly use Barco AOI to inspect film. The AccuMatch compares pixel-to-pixel of the Gerber data to the image seen by the AOI camera. It's slower than design rule checking, but has definite advantages [like lower falsing]. Unfortu

x-y data generation

Electronics Forum | Tue Feb 01 11:34:55 EST 2005 | Dougs

Has anyone heard of any software that can be used to clean up or manipulate x-y placement data. We are a small contract manufacturer with various customers, some who supply good x-y data to component centres and some who supply x-y data to a pin or

x-y data generation

Electronics Forum | Wed Jul 06 09:05:27 EDT 2005 | namc

Try scancad -- http://www.scancad.com/

x-y data generation

Electronics Forum | Wed Jul 06 09:06:23 EDT 2005 | Jack

Try scancad -- http://www.scancad.com/

Machine data for SPC?

Electronics Forum | Thu May 26 18:19:01 EDT 2005 | darby

You should be able to export this data from each machine into an ascii format. Import into Excel and do what you want with it. I don't see that you should have to pay for any software at all. If you are not familiar with Excel and macros etc then get

x-y data generation

Electronics Forum | Tue Feb 01 22:10:09 EST 2005 | davef

Try: http://www.gerbergrab.co.uk We have no relationship, nor receive benefit from the company referenced above.

x-y data generation

Electronics Forum | Tue Feb 01 22:31:51 EST 2005 | Passerby

I may be wrong, but I think one of smtnet's advertisers have something that does this too.. No idea how good, bad or ugly it is or even if appropriate, but try: http://www.unisoft-cim.com/gerber_connection.htm