Electronics Forum | Fri Jun 22 08:36:54 EDT 2012 | jandre1953
Sir: You did not state what kind of screen printer, all the others assumed it was for SMT. We are dealers for ATMA line of screen printing and aux. eqpt. They make a first class, well made press, and are probably the largest in the world now. Over 4,
Electronics Forum | Fri Aug 12 10:41:04 EDT 2011 | eezday
I believe you've gotten some wise advice about finding a working board rather than attempting repair. If you decide to attempt the repair, checking or replacing the regulators is a reasonable starting point (primary power). The next thing I would d
Electronics Forum | Fri Aug 12 17:36:06 EDT 2011 | grics
Dave is correct. Also, you should check the TDS's of the caps and the display before processing to see if they can withstand the process temps, look for a recommended solder profile or info for the manufacturability of the device. On another note,
Electronics Forum | Sat Aug 13 10:56:57 EDT 2011 | jldowsey
Process Flow #4 in davef's response is your best bet for this assemblly judging buy your pictures. We purchase our selective wave solder pallets from Ascentec Engineering - they can fabricate a pallet to hold your assemblies, keep the SMT devices pro
Electronics Forum | Wed Sep 21 15:13:08 EDT 2011 | gregcr
Where are you located? Along the same lines, I have a trick I used a couple times when replacing a camera. It is often not the image sensor that goes bad, but the camera electronics behind the sensor. I have had luck taking the camera apart but le
Electronics Forum | Fri Oct 28 14:43:20 EDT 2011 | davef
Some times people make a big deal about things. We're sure that you practice elements of 5S in your day-to-day activities. You just don't call it something, because it just makes sense to do that thing. '5S' has to do with workplace organization The
Electronics Forum | Thu Nov 03 00:21:10 EDT 2011 | haiae
I try to re-adjust some parameter follows your suggestion, but there is no effective result. I just find a key of problem, that is pick speed for components 0805. I just change pick speed from 3 to 4 in last week. After that the machine run well unti
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
Electronics Forum | Wed Nov 23 07:38:49 EST 2011 | davef
We agree with the points made by ScottE above. Additionally, most printers are not heavily loaded. So, you wouldn't have to buy another machine, give-up floor space, purchase and store peculiar tooling, etc. We think Darby does pin transfer. Maybe h
Electronics Forum | Thu Jan 26 11:42:58 EST 2012 | davef
Here's what we hear you saying: * Trying to repair a printed circuit board assembly * There's a problem replacing a 57 pin, 20 thou connector * Can't get enough solder paste on the connector leads * Printing paste, replacing the connector, then reflo