Electronics Forum | Thu Nov 23 06:05:24 EST 2006 | 1B73
The solid content of 1B73 is too low, especiall when you add large amount of thinner, not easy to get enough coating thickness.
Electronics Forum | Fri Feb 18 00:44:44 EST 2005 | Grant
Hi, I would immediately go out and purchase a profiler as you will save the cost of it on rework savings. We use a SlimKIC, and the software with it's so good it will let you adjust the oven temps to make your profile fit your paste specifications
Electronics Forum | Mon Feb 21 16:04:25 EST 2005 | FW
There are some basic suggestions given by everyone that cover most of the requirements. However, I would also like to point out your mention of using a fixture to hold PCB. Are you profiling the board with the fixture? If not, this could be one of th
Electronics Forum | Mon Feb 21 11:25:41 EST 2005 | aj
thanks for all the replies. we clean our Dek Stencils after use with IPA. What gloves do you guys use when cleaning stencils? I have found some info. relating to Latex Gloves as been a possible cause..
Electronics Forum | Tue Mar 08 06:23:25 EST 2005 | aj
Just to let you all know. We got some nitrile powder free gloves and everything is fine now. We tried Vinyl but they were powdered so it really looks like it could be the powder and not the latex but I am sticking with the Nitrile powder free gloves
Electronics Forum | Tue Feb 22 12:03:32 EST 2005 | russ
You may to reduce a little bit more with HASL. for .4mm pitch and such I would maybe go to a 5 mil with your standards.
Electronics Forum | Tue Feb 22 10:32:10 EST 2005 | ptavernier
How do you identifie your future products ? By part-numbers or date code ? Add a letter ? Add labels ? Thank's for your response.
Electronics Forum | Fri Feb 25 12:44:25 EST 2005 | Indy
thanks for all the information... if you have any more please keep them re-flowing.. cheers Indy
Electronics Forum | Mon May 16 13:43:41 EDT 2005 | michaelmcclay
Hi Bobpan, I would like to know if you have access to the original Quad 1000 software? I have an operator who "updated" the configuration software on the Quad and hosed it up.
Electronics Forum | Thu Jan 19 10:53:43 EST 2006 | bobpan
Walter, Read what i posted above about switching the dip switch 8 on dip 1. That will probably solve your problem but once again....make sure you write down all your machine settings because everything will be reset.
