Electronics Forum | Fri Mar 15 18:26:51 EDT 2013 | hegemon
We avoid kapton in this situation due to the thickness. 1 mil additional thickness can equal up to a 20% increase in paste volume at adjacent pads if you are using a 5 mil stencil. But then again, that is not always bad. But must be taken into consid
Electronics Forum | Sat Mar 16 15:53:44 EDT 2013 | duchoang
Can anyone help me to set and run " VOID CALCULATION " on YXLON Xray Machine. Thank you so much.
Electronics Forum | Wed Mar 20 10:17:54 EDT 2013 | cyber_wolf
Don't have a CP7 but I think it has the same loader as a CP643. There are about 15 different sensors that have to be made for the loader and carriers to work properly. Are you doing dual board load ?
Electronics Forum | Wed Mar 20 19:19:23 EDT 2013 | vikkaraja
No I am running a single board. I already have checked few sensors that I thought might be the cause. Still no luck. I will contnue with my troublshooting. Please let me know if you think of anything that might help me with resolving my problem. Tha
Electronics Forum | Fri Sep 20 08:34:30 EDT 2013 | island2013
We've done the same as what Woodsmt has suggested. Bread pans and a ladle. Slow going but safe. We did not have to add anything to the pans to prevent sticking. Woodsmt, did you have to worry about the pot heaters over heating while draining?
Electronics Forum | Thu Mar 21 14:27:56 EDT 2013 | markhoch
Does any of you fine, upstanding, young, persons have any experience with SiPlace's Line Monitor? It looks to be very informative... Just wondering if it's all that it's cracked up to be. Thanks in advance!
Electronics Forum | Fri Mar 22 06:28:47 EDT 2013 | mdang
I would like to get a copy of the CD for Fuji CP643E which has all manual & information on the machine? If you have it, please let me know. Thanks, -Michael
Electronics Forum | Sun Mar 31 16:02:32 EDT 2013 | dilogic
You should ask UIC to enable access t on-line documentation. See the attached sceenshot of my MyUniversal page. regards Dejan
Electronics Forum | Mon Mar 25 14:41:50 EDT 2013 | markhoch
Just a thought, but have you pulled the datasheet for the part and confirmed that the plating on the leads is compatible with your current process/profile?
Electronics Forum | Fri Mar 29 23:55:54 EDT 2013 | isd_jwendell
I found two versions, a very old one (DOS) and a newer one that should run on WinXP. Hope this is what you were looking for.