Electronics Forum | Tue Oct 17 18:15:39 EDT 2006 | daxman
Hey all, I just though I give you all a quick update. I managed to get the printer working. The problems were a combination of everything that was discussed here. When I adjusted the GS4 pot for the histogram, I turned the wrong one at first. This t
Electronics Forum | Wed Sep 27 11:38:58 EDT 2006 | sliebl
What are you guys using for SMT Adhesive? When we started into SMT many years ago, we used a Loctite with a pneumatic pump. When we got into automated dispensing with our Contact 3S placement machine, we switched to Heraeus PD955M. It has worked very
Electronics Forum | Thu Oct 26 11:49:54 EDT 2006 | sms_don
CW, The good news is that you are not trying to use SAC paste with SnPb balls for that would be a void generator due to the ball being liquidous while the SAC paste is still in a flux cleaning stage. Two points to consider: One, voids are not an i
Electronics Forum | Thu Oct 05 15:41:36 EDT 2006 | Mario Scalzo, SMT CPE
Good afternoon. From what it sounds like is that the solder joins are not getting hot enough or if it Au, then the increase in the Au content of the joint is increasing the melting point of the final solder joint. To some extent, this will also hap
Electronics Forum | Sun Oct 08 12:00:11 EDT 2006 | grantp
Hi, Just a hint to help your posts. When posting a new thread, try and put something into the subject line that helps people know what the post is about. I think the subject is like a little advertisement for your post to encourage people to click o
Electronics Forum | Thu Oct 19 20:03:04 EDT 2006 | darby
I agree with Stephen there! Or maybe we just didn't care enough about looking into it in the COLD profile days! Back to df: I don't think any manufacturer is going to give you a tolerance level, they'll stick with what they've told you -225. If it's
Electronics Forum | Thu Oct 19 14:20:18 EDT 2006 | sliebl
Something that I find unusual in some of the replies is the fact that local fids that are randomly dropped around the quad don't do anything for assisting the alignment of said quad. The only way that I am aware of the local fids being useful is if t
Electronics Forum | Wed Nov 08 12:21:23 EST 2006 | SWAG
A little more detail on our application: It is a large fixture (approx. 15" x 18") that spans the chain fingers in the reflow. It has several cut-outs and reductions in thickness to allow for better heat distribution. It worked well/stayed flat fo
Electronics Forum | Tue Nov 07 11:04:06 EST 2006 | muse95
What type of hardware are you looking for? Nuts and bolts? Custom machined/stamped parts? In general, stainless steel is usually considered RoHS, but more expensive. However, medical equipment usually uses things like stainless steel. However, som
Electronics Forum | Mon Nov 06 22:01:44 EST 2006 | realchunks
Why a clean room? Or do you mean an environmental room to control temp and RH? Any way, to answer you question, your wave and oven can care less about RH. Just don't keep them at 100% RH. Static can easily be handled with lower RH and proper grou