Electronics Forum | Mon Jun 11 16:40:17 EDT 2007 | mlb
Dear GR, I represent Kyzen Corporation and would like to address a couple points in your message. Both Kyzen and Zestron are global suppliers of engineered cleaning fluids for removing flux residues from electronic assemblies. Aqueous cleaning fl
Electronics Forum | Fri Jun 08 10:48:06 EDT 2007 | rm14
2 waves is correct. While running the glass test panel over the chip wave (1st wave) you can see gaps due to the turbulance. What I did find was the gap of the chip wave was not closing up enough so I adjusted this which made it better. What is the p
Electronics Forum | Thu Jun 07 18:09:21 EDT 2007 | stephan
We noticed unsufficient soldering on some 0805 chips located between pins from a plastic bloc connector . All chips are soldered with 45� angle. Flux quantity , preheating , contact time and PCB quality was checked. Do you know any international stan
Electronics Forum | Thu Jun 14 01:47:23 EDT 2007 | pavel_murtishev
Good morning, Glue printing and glue dispensing processes have their pros and cons. Speed is main glue printing process �pro�. A-n-y dispenser will be slower if you replace your DEK with it. Your placement machines do not wait, right? So I wonder wh
Electronics Forum | Wed Jun 20 07:59:56 EDT 2007 | avalancher
The issue you are seeing is in fact the Battery that is in your machine. It looks like a motorcycle battery. It is usually located somewhere in or around your power supply. It should be reading an output of 18V. This battery is used in the event of a
Electronics Forum | Wed Jun 27 18:10:34 EDT 2007 | kpm135
Just thought I'd let you know the problem was the Batteries. There happened to be three 6 volt 10 Ah batteries hooked in series that were no longer holding voltage. Also we ended up replacing the MI board because there was a fried component on it. Do
Electronics Forum | Wed Jun 20 19:52:47 EDT 2007 | davef
J-STD-001, 5.4 Solderability Maintenance states words to the effect "The manufacturer shall ensure that all components [bla bla bla] are solderable at the start of hand and/or machine soldering operations." So, how many you contractor cats 'n kittie
Electronics Forum | Wed Jun 27 02:24:28 EDT 2007 | jola
Check the drive belt first for missing tooth or bad tension. If thats ok you might need to change the clutches, they need to be changed every second year or soo. If they are worn out the wire driving the spindle might slip causing this problem. This
Electronics Forum | Thu Jun 28 11:01:47 EDT 2007 | mmjm_1099
Hello all, I have a question in regards to part tolerance on parts. I called Fuji (not doubting them at all here just looking for more insight here) and asked them what the usual % tolerance on parts is. They came back with 30% of a part and the tole
Electronics Forum | Mon Jul 02 09:30:19 EDT 2007 | cyber_wolf
Make sure that your C14 tool is black and that the tip is in good condition. Next, create a vision package for the 0402. I assume that your machine has a line scan camera.(Use it) 0402's do not mechanically center well unless your C14 and centering u
